Ingersoll/Rand
INGERSOLL-RAND 77A60P107 Type 27 Angle Grinder 7 in 1.5 hp 6000 RPM
A heavy-duty pneumatic angle grinder for 7 in Type 27 and 28 wheels, delivering 1.5 hp at 6,000 RPM with a safety lever
- Heavy-duty grinding power from 1.5 hp motor
- 6000 RPM maximum speed for fast material removal
- Type 27 and 28 wheel compatibility adds versatility
- Safety lever prevents accidental start-up during use
- 3/8 in NPT female air inlet fits standard connections
INGERSOLL-RAND 77A60P107 Angle Grinder
The INGERSOLL-RAND 77A60P107 is a pneumatic angle grinder built for heavy-duty material removal. It accepts Type 27 and Type 28 wheels with a 7 in diameter and runs at a maximum speed of 6000 RPM. A 1.5 hp motor delivers sustained power for grinding and cutting tasks. The tool features a safety lever and an extended reach design for improved control.
Suited for industrial grinding and cutting
This grinder suits professionals who need a high-capacity air tool for weld preparation, deburring or heavy stock removal. The 3/8 in NPT female air inlet connects to standard shop supply lines. Buyers who require variable speed control or electric operation should look at alternative tools. The fixed 6000 RPM speed and pneumatic drive limit flexibility for precision finishing work.
7 in wheel capacity with 1.5 hp output
The 7 in wheel diameter provides a large contact area for rapid material removal on steel and cast iron. The 1.5 hp rating supplies consistent torque through the 5/8 In.-11 spindle under heavy load. Type 27 and Type 28 wheel compatibility covers common grinding and cutting discs. Extended reach helps access recessed areas but the fixed guard and single speed restrict use on delicate or heat-sensitive materials.
Highlights
- Heavy-duty grinding power from 1.5 hp motor
- 6000 RPM maximum speed for fast material removal
- Type 27 and 28 wheel compatibility adds versatility
- Safety lever prevents accidental start-up during use
- 3/8 in NPT female air inlet fits standard connections
Specifications
| Brand | INGERSOLL-RAND |
|---|
Questions about this item
What air supply and fitting do I need to run the 77A60P107 angle grinder?
Connect the 3/8 in NPT female air inlet to a compressed-air line that can deliver the volume required for a 1.5 hp pneumatic motor at 6000 RPM.
Will the 5/8 in.-11 spindle accept the Type 27 and Type 28 wheels I already own?
Yes, the 5/8 in.-11 spindle thread matches the standard mounting for both Type 27 and Type 28 wheels up to 7 in diameter.
How can I confirm the grinder is reaching its rated 6000 RPM after installation?
Use a contact or laser tachometer on the spindle; a steady reading at or near 6000 RPM under load shows the tool is performing to spec.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
