Ingersoll/Rand
Ingersoll/Rand 24242141 Coalescing Filter Element 1 micron 135 scfm
Removes oil and water aerosols from compressed air with 1 micron coalescing filtration at 135 scfm flow
- MaterialHAWA
- 1 micron coalescing rating removes fine oil and water aerosols
- 135 scfm flow capacity supports high-demand compressed air systems
- Microglass filter media captures sub-micron contaminants efficiently
- Compatible with FA230IG part number for direct replacement fit
- New Ingersoll-Rand element restores original filtration performance
Filter element for coalescing duties
This Ingersoll/Rand 24242141 element removes oil and water aerosols from compressed air down to 1 micron. It suits workshops and plants that need clean air for pneumatic tools or finishing equipment. The microglass media traps fine droplets while letting air pass at the rated flow.
Steady flow at 135 scfm
The element maintains its 1 micron rating during continuous operation rather than only in short tests. Microglass structure resists saturation so pressure drop rises slowly as loading builds. This behaviour keeps downstream gear protected through full shifts without frequent change-outs.
Direct swap for FA230IG housings
Installation means opening the filter bowl, removing the used cartridge and seating this replacement by hand. The common mistake is forgetting to lubricate the O-ring or over-tightening the bowl, which can leak or crack the housing. No special tools are required beyond the standard bowl wrench.
Highlights
- 1 micron coalescing rating removes fine oil and water aerosols
- 135 scfm flow capacity supports high-demand compressed air systems
- Microglass filter media captures sub-micron contaminants efficiently
- Compatible with FA230IG part number for direct replacement fit
- New Ingersoll-Rand element restores original filtration performance
Specifications
| Brand | INGERSOLL-RAND |
|---|---|
| Material | HAWA |
Questions about this item
How much pressure drop or heat does the 24242141 element add when running continuously at 135 scfm?
The coalescing element is rated for 135 scfm flow; pressure drop across a clean 1‑micron microglass cartridge is low, and it adds no measurable heat to the compressed‑air stream.
What housing or adapter must I already own to install the 24242141 filter element?
It fits Ingersoll‑Rand FA230IG series filter housings; the element slides into the existing bowl and seals with the supplied gasket — no extra adapters are required.
Will the 24242141 element work in my older Ingersoll‑Rand compressor that currently uses a FA230IG cartridge?
Yes — the 24242141 is a direct replacement for the FA230IG part number, so it installs in the same housing and restores 1‑micron coalescing performance.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
