Ingersoll/Rand
Ingersoll/Rand 1RTNS1 Air Screwdriver 1/8in FNPT Pistol Grip 30.1 in-lb 1000 RPM 90 psi
Pistol-grip air screwdriver delivers adjustable shut-off torque from 2.7 to 30.1 in-lb at 1,000 RPM free speed
- TypeHex Drive Bits
- Adjustable shut-off clutch prevents over-torquing
- 1 in-lb maximum torque handles demanding fasteners
- 1,000 RPM free speed drives screws quickly
- 1/4-inch quick-change hex bit holder speeds bit swaps
- 45 CFM average consumption suits standard compressors
1/8 in FNPT Air Screwdriver
The Ingersoll/Rand 1RTNS1 is a pistol-grip air screwdriver with a 1/4 in quick-change hex drive. It delivers an adjustable shut-off clutch with a torque range from 2.7 to 30.1 in-lb and a free speed of 1000 RPM. The tool requires 90 psi operating pressure and a minimum 1/4 in hose for industrial assembly tasks.
Sustained-load air consumption
Under continuous operation the tool draws 13.0 CFM at full load. During a typical 15 second run cycle the average consumption drops to 3.45 CFM. The compressor and airline must be sized to supply the full-load figure without pressure sag so the shut-off clutch repeats accurately.
Pre-installation checks
Verify that your compressor can maintain 90 psi while delivering at least 13.0 CFM continuously. Confirm the air line uses a minimum 1/4 in internal diameter hose to avoid excessive pressure drop. Ensure the work area can accommodate the 8 1/2 in overall length of the tool.
Highlights
- Adjustable shut-off clutch prevents over-torquing
- 1 in-lb maximum torque handles demanding fasteners
- 1,000 RPM free speed drives screws quickly
- 1/4-inch quick-change hex bit holder speeds bit swaps
- 45 CFM average consumption suits standard compressors
Specifications
| Brand | Ingersoll-Rand |
|---|---|
| Model | 1RTNS1 |
| Type | Hex Drive Bits |
Questions about this item
How much compressed air does the 1RTNS1 consume during a typical 15-second run?
It averages 3.45 CFM over a 15-second run and draws up to 13.0 CFM under full load at 90 psi.
What air supply and hose does the 1RTNS1 need to operate?
It requires a 90 psi air line with at least a 1/4-inch hose and a 1/8-inch FNPT inlet fitting.
Will the 1RTNS1 accept the 1/4-inch hex bits I already use with my cordless driver?
Yes, it has a 1/4-inch quick-change hex chuck that takes standard 1/4-inch hex drive bits.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
