Ingersoll/Rand
Ingersoll/Rand 1RPNC1 Air Screwdriver 1.5-30.0 in-lb 1000 RPM 1/4" Hex
An adjustable-cushion inline air screwdriver with push-to-start throttle, 1.5 to 30.0 in-lb torque range and 1,000 RPM free speed
- TypeHex Drive Bits
- Adjustable cushion clutch prevents over-torqueing fasteners
- Push-to-start throttle engages instantly on contact
- 5 to 30.0 in-lb torque range covers light assembly
- 1,000 RPM free speed drives screws quickly
- 1/4" hex quick-change chuck accepts standard bits
Inline Air Screwdriver 1.5-30.0 in-lb
The Ingersoll-Rand 1RPNC1 is an adjustable cushion clutch air screwdriver built for industrial assembly and maintenance tasks. Its push-to-start throttle and reversible operation suit technicians who need controlled torque on fasteners. The 1/4-inch hex quick-change chuck accepts standard bits for rapid changeover.
Build Quality and Daily Use
An in-line body style keeps the tool balanced during extended runs at 1,000 RPM free speed. The 1/8-inch NPT air inlet and 1/4-inch minimum hose size connect to common shop supply lines. Average air consumption is 5.00 CFM at a 15-second run time and 13.0 CFM at full load, so compressor capacity must match demand.
Compatibility Check Before Ordering
Verify that your air system delivers 90 psi at the tool inlet under load. Ensure the hose and fittings support the required flow without excessive pressure drop. Confirm that the 1/4-inch hex drive matches the bits used in your application. Buyers who need higher torque or a pistol-grip form factor should consider other models.
Highlights
- Adjustable cushion clutch prevents over-torqueing fasteners
- Push-to-start throttle engages instantly on contact
- 5 to 30.0 in-lb torque range covers light assembly
- 1,000 RPM free speed drives screws quickly
- 1/4" hex quick-change chuck accepts standard bits
Specifications
| Brand | Ingersoll-Rand |
|---|---|
| Model | 1RPNC1 |
| Type | Hex Drive Bits |
Questions about this item
What torque range does the adjustable cushion clutch actually deliver?
The clutch is rated for a soft-draw torque range of 1.5 to 30.0 in-lb with a maximum torque of 30.1 in-lb at 90 psi.
What size air hose and inlet fitting does this screwdriver require?
It needs a minimum 1/4 in hose and connects via a 1/8 in NPT air inlet.
How do you install the bit in the quick-change chuck, and what step is often missed?
Pull the collar back, insert the 1/4 in hex bit until it seats, then release the collar fully to lock it; the step people skip is verifying the bit is fully seated before releasing the collar.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
