We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black ultra low profile OBD2 Y splitter cable one male to three female connectors 50cm length

iKKEGOL

iKKEGOL OBD2 1 to 3 Ultra Low Profile 16 Pin Male to Female Y Splitter Cable 50cm / 20

SKU CH-9NFX-2N708

Splits one OBD-II port into three simultaneous connections using a 50 cm ultra-low-profile cable with direct pass-through on pins 2, 4, 5, 6, 7, 10, 14, 15 and 16

  • Type3 way obd cable
  • ColorBlack
  • Splits one OBD-II port into three simultaneous connections
  • Ultra low profile fits tight spaces behind the dash
  • Direct pass-through on pins 2 4 5 6 7 10 14 15 16 for full protocol support
  • Flat flexible cable routes easily around obstacles
  • 50 cm length gives convenient reach without excess slack

Ultra Low Profile OBD2 Splitter

The iKKEGOL OBD2 1 to 3 splitter cable turns a single 16-pin diagnostic port into three female J-1962 sockets. It is designed for technicians or owners who need to run multiple scan tools, GPS trackers or data loggers simultaneously. The ultra low profile housing fits tight spaces behind dash panels where standard splitters cannot reach.

Direct Pin Pass-Through Wiring

Pins 2, 4, 5, 6, 7, 10, 14, 15 and 16 are connected straight through from the male plug to each female connector. This wiring preserves the standard OBD2 protocols without signal degradation between devices. The 50 cm flat flexible cable routes cleanly along trim panels and resists common automotive fluids such as oil and fuel.

Three Device Capacity Limit

The splitter supports three OBD2 devices at once, sharing the vehicle's single diagnostic bus. Bandwidth and power are limited to what the port provides, so high-draw accessories or simultaneous high-speed logging may exceed practical headroom. Builders needing more than three connections or isolated circuits will require a different solution.

Highlights

  • Splits one OBD-II port into three simultaneous connections
  • Ultra low profile fits tight spaces behind the dash
  • Direct pass-through on pins 2 4 5 6 7 10 14 15 16 for full protocol support
  • Flat flexible cable routes easily around obstacles
  • 50 cm length gives convenient reach without excess slack

Specifications

Type3 way obd cable
ColorBlack

Questions about this item

How many OBD-II devices can I connect at once without signal conflicts?

The splitter provides three female J-1962 ports so you can run up to three diagnostic tools or trackers simultaneously from one vehicle port.

Does the cable generate noticeable heat or draw extra power during continuous use?

It is a passive wiring harness with no active electronics, so it adds no measurable heat or power draw beyond the devices you plug in.

What must my vehicle already have for this splitter to work?

Your vehicle needs a standard 16-pin OBD-II J-1962 socket; the splitter plugs directly into that port and requires no additional adapters.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.