We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black 60 cm OBD2 16-pin male to dual female ribbon splitter with power switch

iKKEGOL

iKKEGOL 60cm OBD2 16 Pin Male to Dual Female Splitter Cable with Power Switch

SKU CH-VMQH-RMBWP

Splits one OBD-II port into two female sockets with a 60 cm ribbon cable and an integrated power switch to protect the vehicle battery

  • TypeCar Mount
  • Convenient power control with built-in switch and indicator light
  • Flat ribbon angled connectors for flexible, durable installation
  • Direct 16-pin pass-through supporting standard OBD2 protocols
  • Dual female ports let you keep a tracker plugged in while adding a scanner
  • 60 cm extension relocates heavy adapters away from footwell

OBD2 16 Pin Splitter with Power Switch

This iKKEGOL cable splits a single vehicle OBD2 port into two female J1962 sockets. A 60 cm flat ribbon carries all 16 pins straight through for full protocol support. One socket stays free for a permanent device such as a GPS tracker while the other accepts a scan tool. The integrated switch cuts power to avoid battery drain when the ignition is off.

Thermals Noise and Power Draw

The passive ribbon cable generates no heat and makes no noise during operation. Power consumption is limited to the connected devices because the switch isolates the circuit when turned off. No active components or fans are present so the assembly adds zero thermal load to the cabin.

Build Quality and Daily Use

Low profile male J1962 and dual female J1962 connectors use angled flat ribbon ends for flexibility in tight footwells. The 24 inch length lets a heavy scanner or modem sit clear of pedals and knees. Black insulation resists wear from repeated plug cycles and under dash heat.

Highlights

  • Convenient power control with built-in switch and indicator light
  • Flat ribbon angled connectors for flexible, durable installation
  • Direct 16-pin pass-through supporting standard OBD2 protocols
  • Dual female ports let you keep a tracker plugged in while adding a scanner
  • 60 cm extension relocates heavy adapters away from footwell

Specifications

TypeCar Mount

Questions about this item

How do I install the 60cm OBD2 splitter and what step is often missed?

Plug the low-profile J1962 male end into the vehicle port, then attach your devices to the dual J1962 female ends; the step often missed is toggling the power switch on so the scanner receives power.

What maintenance or replacement will the 60cm OBD2 splitter need later?

Inspect the 16-pin flat ribbon and angled connectors periodically for wear or corrosion; replace the cable if the insulation cracks or pins become loose.

What limit appears first on the 60cm OBD2 splitter during sustained use?

The 60cm ribbon length and 16-pin direct pass-through design set the practical limit; excessive tension or tight bends can degrade signal integrity over time.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.