Hyde Tools
Hyde Tools 43420 Paint Mixer 11 in 500 RPM
A 11 inch steel and polypropylene paint mixer for one gallon cans, rated to 500 RPM for use with electric drills
- TypeOthers
- Mixes one-gallon paint cans efficiently with 11-inch shaft reaching deep into containers
- 500 RPM maximum speed prevents splashing while blending thick coatings thoroughly
- 1/4-inch shaft diameter fits standard electric drill chucks for quick setup
- 2-5/8 inch dual impellers create strong vortex action for uniform colour consistency
- Steel and polypropylene construction resists corrosion and solvent damage during repeated use
What this paint mixer does
The Hyde Tools 43420 Paint Mixer attaches to an electric drill to blend one gallon of paint. Its 11 inch shaft reaches into standard cans while the 2-5/8 inch dual impellers fold through the liquid for a uniform mix. Steel and polypropylene construction resists corrosion from solvents and water-based coatings.
Behaviour during extended mixing
Rated for a maximum of 500 RPM, the mixer maintains steady torque without overheating the drill motor during the minutes needed to incorporate settled pigment. The folded impeller design reduces splashing compared with single-blade stirrers, keeping the work area cleaner throughout the job.
Check your drill before ordering
Verify that your electric drill accepts a 1/4 inch shaft and can be limited to 500 RPM or lower; higher speeds will exceed the mixer's rating. Ensure the chuck grips the shaft securely so the impellers cannot wobble or detach while spinning.
Highlights
- Mixes one-gallon paint cans efficiently with 11-inch shaft reaching deep into containers
- 500 RPM maximum speed prevents splashing while blending thick coatings thoroughly
- 1/4-inch shaft diameter fits standard electric drill chucks for quick setup
- 2-5/8 inch dual impellers create strong vortex action for uniform colour consistency
- Steel and polypropylene construction resists corrosion and solvent damage during repeated use
Specifications
| Brand | Hyde Mfg. |
|---|---|
| Type | Others |
Questions about this item
Will the 500 RPM motor overheat if I mix paint all afternoon?
The 500 RPM rating is a maximum speed; actual heat depends on your drill and mixing load, so take breaks if the drill body feels hot.
What size drill chuck is needed for the 1/4 in shaft on this 43420 mixer?
The shaft is 1/4 in diameter, so it fits any standard drill chuck that accepts 1/4 in bits or larger.
Can the 11 in shaft reach the bottom of a standard 1-gallon can I already own?
Yes, the 11 in length is designed for 1-gallon cans, letting the impellers sit near the bottom for thorough mixing.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
