HOUGEN
HOUGEN 17922 23mm x 25mm RotaLoc Plus annular cutter pneumatic accessory
Cuts 23 mm holes to 25 mm depth using the RotaLoc Plus quick-change system
- 23mm cutting diameter matches hole requirements
- 25mm depth of cut handles thick material
- RotaLoc Plus shank enables quick tool changes
- Hougen 17922 model ensures brand reliability
- California Prop 65 notice informs user safety
HOUGEN 17922 annular cutter
The HOUGEN 17922 is a RotaLoc Plus annular cutter designed for pneumatic drilling applications. It suits metalworking professionals who need precise hole-cutting in structural steel and similar materials. The cutter mounts directly to compatible RotaLoc Plus drive systems for quick changes. California Proposition 65 applies because the product contains a listed chemical.
Sustained cutting performance
Under continuous pneumatic load the cutter maintains consistent material removal without the wandering common in twist drills. The annular geometry ejects a solid slug rather than producing fine chips, reducing heat buildup in the workpiece. Steady feed pressure and adequate lubrication extend edge life during repeated cuts. Operators should monitor cutter temperature during long production runs.
Compatibility checks before ordering
Verify that your magnetic drill or pneumatic drive unit accepts the RotaLoc Plus shank interface before purchase. Confirm the required cutting depth matches the 25 mm length of cut on this model. Ensure the workpiece material and thickness are suitable for a 23 mm diameter cutter. Check that your air supply delivers the pressure and volume the drive unit specifies.
Highlights
- 23mm cutting diameter matches hole requirements
- 25mm depth of cut handles thick material
- RotaLoc Plus shank enables quick tool changes
- Hougen 17922 model ensures brand reliability
- California Prop 65 notice informs user safety
Specifications
| Brand | HOUGEN |
|---|
Questions about this item
How much air does the 17922 annular cutter consume during continuous operation?
The cutter is designed for standard pneumatic systems; match your compressor output to the tool’s rated CFM for steady cutting.
Which magnetic drill chucks accept the RotaLoc Plus shank on this 23 mm x 25 mm cutter?
The RotaLoc Plus shank fits Hougen and compatible magnetic drills that use the same quick-change interface.
Will the 17922 cutter work on a magnetic drill that only takes the original RotaLoc shank?
No, the RotaLoc Plus shank is not backward-compatible with the original RotaLoc drive.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
