HOUGEN
HOUGEN 12222S 11/16 in. X 2 in. 12000-Series Annular Cutter Stack Cut pneumatic accessory
11/16 inch by 2 inch annular cutter for stack cutting with 12,000-Series compatibility
- Cuts 11/16 in. holes with 2 in. depth of cut
- 12,000-Series annular cutter designed for stack cutting applications
- HOUGEN brand ensures professional-grade cutting performance
- New condition delivers full factory cutting precision
- Pneumatic accessory compatible with magnetic drill systems
11/16 in. annular cutter
The HOUGEN 12222S is an 11/16 in. by 2 in. annular cutter from the 12000-Series Stack Cut range. It is designed for pneumatic drilling applications where a clean, precise hole is required in stack-cutting scenarios. The accessory targets metalworking professionals and maintenance teams needing reliable hole-making performance.
Replaces worn or undersized cutters
This cutter replaces dull or damaged annular cutters of the same 11/16 in. diameter and 2 in. depth of cut. The upgrade is worthwhile when an existing tool no longer produces clean holes in stacked material or when a job demands the specific Stack Cut geometry for multiple layers. It restores cutting efficiency without changing the magnetic drill setup.
Check drill compatibility and material
Verify that your magnetic drill or pneumatic drive accepts the 12000-Series shank configuration before ordering. Confirm the workpiece material and stack thickness are suited to the 2 in. cutting depth and 11/16 in. diameter. Ensure the pneumatic supply delivers the pressure and flow the cutter requires for optimal performance.
Highlights
- Cuts 11/16 in. holes with 2 in. depth of cut
- 12,000-Series annular cutter designed for stack cutting applications
- HOUGEN brand ensures professional-grade cutting performance
- New condition delivers full factory cutting precision
- Pneumatic accessory compatible with magnetic drill systems
Specifications
| Brand | HOUGEN |
|---|
Questions about this item
What arbor diameter does the 11/16 in. annular cutter need for the 12000-Series holder?
The cutter uses an 11/16 in. cutting diameter and is built for the 12000-Series system; the matching arbor diameter is determined by that series.
Which step is most often missed when fitting the cutter into a pneumatic mag-drill?
Operators frequently forget to seat the pilot pin fully before locking the cutter, so the pin cannot eject the slug during the cut.
When should the pilot pin be replaced on this stack-cut cutter?
Replace the pilot pin when its tip shows visible wear or when the slug stops ejecting cleanly from the 2 in. depth of cut.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
