HNZXIB
HNZXIB VC-2 2 Gallon Vacuum Chamber Stainless Steel Transparent Lid Gauge
A 2-gallon stainless steel vacuum chamber with an 18mm transparent polycarbonate lid, silicone sealing ring, and shockproof gauge for degassing and lab filtration
- TypeLab Filtration
- Capacity2 Gallon
- 2 gallon capacity fits larger degassing batches
- 18 mm polycarbonate lid gives clear view without deformation
- Silicone gasket resists butane and solvents for tight seal
- Shockproof oil-filled gauge reads to 0.5 inHg accuracy
- Ultra-thick stainless barrel handles high vacuum pressure safely
2-Gallon Vacuum Chamber for Degassing
This 2-gallon vacuum chamber provides a 9-litre stainless-steel barrel with a transparent polycarbonate lid for visual monitoring. It is built for laboratory degassing of silicone, resin and other solutions where bubble removal is required. The oil-filled shockproof gauge and silicone sealing ring support consistent vacuum levels during each cycle.
Suited for resin casting and small-batch lab work
Users needing a compact, corrosion-resistant vessel for intermittent degassing will find the 240-by-200-millimetre barrel and 18-millimetre lid practical. The design is not intended for continuous high-throughput production or for processes that demand a larger internal volume than two gallons.
Sustained vacuum holds with thick-wall construction
The ultra-thick stainless-steel barrel and 18-millimetre polycarbonate lid resist deformation during extended pump-down periods. The oil-filled gauge maintains 0.5 inHg accuracy throughout long runs, while the silicone gasket preserves seal integrity without frequent replacement.
Highlights
- 2 gallon capacity fits larger degassing batches
- 18 mm polycarbonate lid gives clear view without deformation
- Silicone gasket resists butane and solvents for tight seal
- Shockproof oil-filled gauge reads to 0.5 inHg accuracy
- Ultra-thick stainless barrel handles high vacuum pressure safely
Specifications
| Type | Lab Filtration |
|---|---|
| Capacity | 2 Gallon |
Questions about this item
What vacuum pump do I need to connect to the 0.5 inHg accuracy gauge on the VC-2 chamber?
Any pump with a standard hose fitting that can pull a vacuum within the gauge's 0.5 inHg accuracy range will work; the chamber uses a common valve assembly for connection.
Will the 18mm thick polycarbonate lid resist solvents like acetone that I use with older resin setups?
The lid is made from polycarbonate rated 30x tougher than acrylic, and the silicone gasket resists butane and other solvents, offering strong chemical compatibility.
How do I verify the shockproof, oil-filled gauge is reading correctly after I install the silicone sealing ring?
Close the valve, run your pump, and watch the needle stabilise; the oil-filled, shockproof gauge with 0.5 inHg accuracy will show a steady vacuum level if the seal is airtight.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
