HNZXIB
HNZXIB S-80L 80L 110V Jacketed Glass Reactor laboratory supply
An 80-litre jacketed glass reactor with GG17 borosilicate vessel, 120 W stirring motor adjustable to 600 rpm, PTFE agitator, stainless-steel frame and 110 V power supply
- TypeGlass Reactor
- Capacity80L
- Voltage110V
- 80 L capacity handles large-scale synthesis batches
- 110 V 50/60 Hz supply fits standard laboratory mains
- 0–600 rpm stirring range with 120 W motor covers gentle to vigorous mixing
- GG17 high-borosilicate glass resists thermal shock and chemical attack
- SUS304 stainless-steel frame provides rigid corrosion-resistant support
80L Jacketed Glass Reactor for Laboratory Synthesis
The HNZXIB S-80L is an 80L double-layer glass reactor designed for synthetic chemical, bio-pharmaceutical and new material preparation. It operates on a 110V 50/60Hz supply and uses GG17 high-borosilicate glass for chemical resistance. An electric stir motor with a PTFE agitator and universal joint provides mechanical stirring inside the vessel. A stainless steel SUS304 frame supports the assembly.
Thermals and Power in Normal Operation
The 120W gear motor delivers a speed range of 0 to 600 rpm with a maximum of 1300 rpm and a torque of 1500 g/cm. A circulating thermal medium in the jacket enables both high and low temperature reactions using freezing liquid, water or hot oil. The jacket also removes reaction heat quickly when water cycles through it. An LCD display and a reserved glass thermometer casing allow temperature monitoring during the process.
Replaces Smaller Vessels and Open-System Setups
This reactor upgrades from smaller capacity vessels or open beaker configurations that cannot maintain vacuum or precise jacketed temperature control. The 80L volume suits pilot-scale batches where a 12 mm stirring shaft and large bottle mouth simplify cleaning and charging. It is not suited for buyers who need a higher torque rating than 1500 g/cm or a stirring speed above 1300 rpm. The 110V requirement limits use in regions without that supply.
Highlights
- 80 L capacity handles large-scale synthesis batches
- 110 V 50/60 Hz supply fits standard laboratory mains
- 0–600 rpm stirring range with 120 W motor covers gentle to vigorous mixing
- GG17 high-borosilicate glass resists thermal shock and chemical attack
- SUS304 stainless-steel frame provides rigid corrosion-resistant support
Specifications
| Type | Glass Reactor |
|---|---|
| Capacity | 80L |
| Voltage | 110V |
Questions about this item
How do I install the 12 mm stirring shaft with the PTFE agitator and universal joint, and what step is often missed?
Mount the motor to the SUS304 frame, insert the 12 mm shaft through the universal joint into the PTFE agitator, and secure the locking collar. The step often missed is aligning the universal joint before tightening, which prevents wobble at speeds up to 600 rpm.
What maintenance or replacement will the GG17 high-borosilicate glass vessel and PTFE agitator need over time?
Inspect the glass for micro-cracks after each thermal cycle and clean the large bottle mouth thoroughly. Replace the PTFE agitator if the blades show wear or chemical attack, and check the bottom drain valve seal annually.
What limit appears first during sustained operation at 1300 rpm with the 120 W motor?
Motor torque drops as speed approaches 1300 rpm, so the practical continuous limit is the 1500 g/cm torque rating at lower speeds. Extended high-speed runs may trigger thermal protection on the 110 V 50/60 Hz supply.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
