HNZXIB
HNZXIB RE-501 Factory Price 5L Rotary Evaporator 110V
A 5-litre rotary evaporator with digital speed control up to 120 rpm, 1500 W bath heating, PTFE and fluoro-rubber seals, and a double backflow condenser for efficient solvent recovery
- TypeRotary Evaporator
- Capacity5L
- Voltage110V
- 5 L evaporating flask for high-volume solvent recovery
- digital speed control 0-120 r/min for precise evaporation
- ±1 °C bath accuracy protects temperature-sensitive compounds
- PTFE and fluoro-rubber seals resist chemical corrosion
- CE certified with US plug for 110 V supply
5 L rotary evaporator for solvent recovery
The HNZXIB RE-501 is a 5 L rotary evaporator designed for laboratory distillation and solvent recovery. It operates on 110 V mains power and uses a motorised rotating flask to spread a thin liquid film for efficient evaporation. A built-in water or oil bath provides heating up to 1500 W while a double reflux condenser cools vapour for collection. Digital speed control and manual lift adjustment complete the system.
Suited for labs needing 5 L batch capacity
This unit suits laboratories that require a 5 L evaporating flask and a 3 L receiving flask for routine concentration or purification work. The 110 V supply and US plug make it ready for North American bench power. Buyers who need a larger evaporating volume, automated lifting, or a 220 V supply as standard should look at alternative configurations.
5 L evaporating flask defines batch volume
The 5 L evaporating flask sets the maximum batch size for each distillation run. The matching 3 L receiving flask determines how much condensed solvent can be collected before emptying. Both glass components are high borosilicate, and the PTFE and fluoro rubber seals resist corrosion from aggressive solvents. Match these capacities to your typical sample volumes before purchasing.
Highlights
- 5 L evaporating flask for high-volume solvent recovery
- digital speed control 0-120 r/min for precise evaporation
- ±1 °C bath accuracy protects temperature-sensitive compounds
- PTFE and fluoro-rubber seals resist chemical corrosion
- CE certified with US plug for 110 V supply
Specifications
| Type | Rotary Evaporator |
|---|---|
| Capacity | 5L |
| Voltage | 110V |
Questions about this item
How do I install the RE-501 and what step do people get wrong?
Connect the US plug to a 110V 60Hz supply, mount the double backflow condenser, fit the 5L evaporating and 3L receiving flasks with PTFE and fluoro rubber seals, then set the manual screw rod lift height up to 150mm. The step often missed is verifying vacuum reaches 0.098Mpa before heating the 1500W bath.
What maintenance or replacement will the RE-501 need later?
Replace PTFE and fluoro rubber seals when vacuum drops below 0.098Mpa, inspect high borosilicate glassware for cracks, clean the 28cm by 17cm water or oil bath to maintain ±1°C accuracy, and lubricate the manual screw rod lift mechanism periodically.
What limit appears first during sustained use of the RE-501?
The 1500W bath temperature stability at ±1°C and the 0.098Mpa vacuum degree are the first limits under continuous operation; the 40W motor maintains 0-120 r/min digital speed regulation, but seal wear or bath scaling can reduce evaporation efficiency before motor torque becomes an issue.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
