HNZXIB
HNZXIB RE-501 5L 110V Rotary Evaporator with Chiller and Vacuum Pump laboratory supply
A 5 L rotary evaporator with manual lift, digital speed control up to 120 r/min, a chiller reaching −20 °C and a dual-tap vacuum pump, all on 110 V power
- TypeRotary Evaporator
- Capacity5L
- Voltage110V
- 5 L evaporating flask handles large volumes in a single run
- 0–120 r/min digital speed control lets you match rotation to solvent
- Integrated chiller cools to –20 °C for efficient vapour recovery
- Dual-tap vacuum pump reaches 0.098 Mpa for strong, steady vacuum
- Manual screw-lift with 150 mm travel simplifies flask positioning
Turnkey 5 L Rotary Evaporator System
The HNZXIB RE-501 delivers a complete distillation package for laboratory professionals who need a ready-to-run setup. It combines a 5 L hand-lifting evaporator, a circulating chiller and a dual-tap vacuum pump in one shipment.
Manual Lift 150 mm Travel and 1500 W Bath
The evaporator uses a screw-rod lift with 150 mm vertical travel and a 1500 W water-oil bath held to ±1 °C accuracy. The chiller provides a 5 L tank rated to -20 °C, while the pump achieves 0.098 Mpa vacuum through two suction taps.
5 L Evaporating Flask with Digital Speed Control
The 5000 ml high-borosilicate flask rotates at 0-120 r/min under 40 W stepless motor control with digital readout. PTFE and fluoro-rubber seals join a double-backflow condenser for solvent recovery at approximately 1 L/H.
Highlights
- 5 L evaporating flask handles large volumes in a single run
- 0–120 r/min digital speed control lets you match rotation to solvent
- Integrated chiller cools to –20 °C for efficient vapour recovery
- Dual-tap vacuum pump reaches 0.098 Mpa for strong, steady vacuum
- Manual screw-lift with 150 mm travel simplifies flask positioning
Specifications
| Type | Rotary Evaporator |
|---|---|
| Capacity | 5L |
| Voltage | 110V |
Questions about this item
How do I set up the hand-wheel lift and what step is often missed?
Mount the unit on a level bench, connect the 110V US plug, attach the 5L evaporating flask and 3L receiving flask to the double backflow condenser, then secure the PTFE and fluoro rubber seals before adjusting the 0-150mm lift; the step most often missed is verifying the vacuum seal at 0.098Mpa before heating.
What maintenance will the chiller and vacuum pump need over time?
The DLSB5/20 chiller with its 5L tank cooling to -20°C requires periodic coolant checks and condenser cleaning, while the SHZ-D(III) pump with two suction taps needs regular oil changes and seal inspections to maintain the 0.098Mpa vacuum degree.
What limit appears first during a long distillation run?
The 1500W water/oil bath heating a 28*17cm bath with ±1°C accuracy and the 40W motor running at 0-120 r/min will hit the 1 L/H evaporation rate ceiling before the 150mm lift range or vacuum capacity become limiting factors.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
