HNZXIB
HNZXIB RE-501 5000ml rotary evaporator set with chiller and vacuum pump
A 5 L rotary evaporator with hand-wheel lift, digital speed control to 120 r/min, a -20 °C chiller and dual-tap vacuum pump for solvent recovery
- TypeRotary Evaporator
- Capacity5000ml
- Voltage220V
- 5 L evaporating flask for large-volume distillation
- Hand-wheel lifting gives 0-150 mm height adjustment
- Digital speed control from 0-120 r/min
- Chiller cools to -20 °C with 5 L tank
- Vacuum pump reaches 0.098 MPa with dual suction taps
5000ml rotary evaporator system
The HNZXIB RE-501 is a complete turnkey distillation set built for laboratory professionals who need a ready-to-run 5L evaporation platform. It combines the rotary evaporator, a circulating chiller and a dual-tap vacuum pump in a single 220V package.
Hand-wheel lift and glassware safety
The evaporator uses a screw-rod manual lift with 150mm travel so the 5L flask can be raised or lowered without tools. High borosilicate glassware and PTFE plus fluoro rubber seals handle vacuum to 0.098Mpa, while the wooden crate protects components during transit.
1L per hour water evaporation rate
At 40W motor power and 0-120 r/min digital speed control, the system achieves an evaporation rate of 1 L/H for water, making it suitable for concentration and purification of heat-sensitive biological samples.
Highlights
- 5 L evaporating flask for large-volume distillation
- Hand-wheel lifting gives 0-150 mm height adjustment
- Digital speed control from 0-120 r/min
- Chiller cools to -20 °C with 5 L tank
- Vacuum pump reaches 0.098 MPa with dual suction taps
Specifications
| Type | Rotary Evaporator |
|---|---|
| Capacity | 5000ml |
| Voltage | 220V |
Questions about this item
What vacuum level does the 0.098 MPa rating allow the RE-501 to reach in practice?
The 0.098 MPa vacuum degree lets the system pull a deep vacuum for efficient solvent removal at lower boiling points.
What are the bath diameter and depth that the 5000 ml flask sits in?
The water/oil bath measures φ28 cm diameter by 17 cm depth to accommodate the 5 L evaporating flask.
How do you level the condenser before the first run on the RE-501?
Adjust the manual screw-rod lift 0-150 mm until the condenser is vertical, then lock the hand-wheel before applying vacuum.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



