HNZXIB
HNZXIB RE-5002 50L Rotary Evaporator 220V Handwheel Lifting Water Bath
50L rotary evaporator with 220V power, 7000W water bath, 1.5m² condenser and PTFE sealing for solvent separation
- TypeRotary Evaporator
- Capacity50L
- Voltage220V
- 50 L capacity handles large-volume solvent recovery
- Digital 0–90 rpm control gives precise rotation speed
- Vertical double condenser with 1.5 m² cooling surface ensures high evaporation rate
- 7 000 W water bath with ±1 °C stability maintains consistent heating
- PTFE sealing system holds 0.098 Mpa vacuum for efficient separation
50 L rotary evaporator for solvent recovery
The HNZXIB RE-5002 is a 50 L rotary evaporator designed for solvent separation and essential oil concentration in laboratory and pilot-scale settings. It operates on 220 V power with a 7000 W water bath and a 250 W motor driving rotation speeds from 0 to 90 r/min shown on a digital display. The system achieves an evaporation rate above 9 L/H for water under a vacuum degree of 0.098 Mpa.
Vertical double condenser and PTFE sealing
A vertical double condenser provides 1.5 m² of cooling surface to support high recovery rates during continuous operation. The PTFE sealing system maintains vacuum integrity while resisting chemical attack from aggressive solvents. The water bath lifts via handwheel or optional electric hoist, allowing the operator to raise or lower the 50 L evaporating and receiving flasks without manual lifting of heavy glassware.
Requires air switch and optional explosion-proof
The unit ships without a plug; the installer must provide a suitable air switch for the 220 V 50–60 Hz supply, with 110 V or 380 V configurations available on request. Temperature control covers RT to 99 °C as standard with a ±1 °C fluctuation, and an optional range up to 250 °C can be specified. An explosion-proof configuration is offered for environments that require it.
Highlights
- 50 L capacity handles large-volume solvent recovery
- Digital 0–90 rpm control gives precise rotation speed
- Vertical double condenser with 1.5 m² cooling surface ensures high evaporation rate
- 7 000 W water bath with ±1 °C stability maintains consistent heating
- PTFE sealing system holds 0.098 Mpa vacuum for efficient separation
Specifications
| Type | Rotary Evaporator |
|---|---|
| Capacity | 50L |
| Voltage | 220V |
Questions about this item
What voltage and frequency does the RE-5002 require, and what is the maximum current draw at 110 V?
The unit runs on 220 V at 50–60 Hz; at 110 V the current can reach 64 A, so 380 V is recommended for lower amperage.
What are the flask sizes and condenser cooling area, and how much bench space should I allow for the vertical double condenser?
Both evaporating and receiving flasks are 50 L, and the condenser provides 1.5 m² of cooling surface in a vertical double-coil layout.
How is the water bath lifted during setup, and what is the common mistake users make when wiring the unit?
The bath uses a handwheel lifting mechanism; the unit ships without a plug and must be hard-wired to an air switch, not a standard outlet.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
