HNZXIB
HNZXIB 50L Double Condensers Rotary Evaporator D-R1050 110V
A 50L rotary evaporator with double condensers for high evaporation efficiency, motorised water-bath lifting and PTFE discharge valve
- TypeRotary Evaporator
- Capacity50L
- Voltage220V
- 50 L capacity for large-volume distillation
- Double condensers achieve over 95 % collection rate
- Motorised water-bath lift enables precise temperature control
- Frequency-conversion speed regulation for stable rotation
- PTFE discharge valve prevents solvent contamination
50L Capacity Double Condenser Rotary Evaporator
The HNZXIB D-R1050 is a 50L rotary evaporator built for laboratory distillation and solvent recovery. Double main condensers increase the condensation surface area, supporting a collection rate above 95 percent. An integrated LCD panel and frequency-controlled motor provide precise speed regulation. The PTFE discharge valve prevents solvent contamination during discharge.
Suited for high-volume solvent recovery
This unit serves labs that process large batches and require automated water-bath lifting for repeatable heating. The continuous feed inlet valve enables unattended operation over long runs. Facilities needing a smaller footprint, lower voltage supply, or a basic manual-lift evaporator should evaluate other models.
Operates on 220V supply despite 110V model reference
The specification sheet lists a 220V voltage requirement, so the installation must provide a compatible 220V circuit. Verify the electrical supply before purchase to avoid mismatched wiring or the need for a step-up transformer.
Highlights
- 50 L capacity for large-volume distillation
- Double condensers achieve over 95 % collection rate
- Motorised water-bath lift enables precise temperature control
- Frequency-conversion speed regulation for stable rotation
- PTFE discharge valve prevents solvent contamination
Specifications
| Type | Rotary Evaporator |
|---|---|
| Capacity | 50L |
| Voltage | 220V |
Questions about this item
How is the rotating flask installed and what step is commonly missed?
The flask connects to the vapor tube with a clip; the step often missed is seating the PTFE seal fully before tightening so vacuum holds.
What maintenance will the double condensers and PTFE discharge valve need later?
Clean both condenser coils after each run to prevent residue buildup and inspect the PTFE valve seal annually for wear.
What limit appears first during sustained evaporation at the 50L capacity?
The 95% collection rate drops if the water bath temperature cannot keep pace with the solvent load, making heat transfer the limiting factor.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
