HNZXIB
HNZXIB 2L Rotary Evaporator RE201D with 5L -10°C Chiller DLSB5/10 110V
A 2 L rotary evaporator with digital speed control up to 120 r/min and a 5 L circulating chiller reaching −10 °C, powered at 110 V/60 Hz
- TypeRotary Evaporator
- Capacity2L
- Voltage110V
- 2L evaporating flask handles up to 2000ml samples
- Digital speed control from 0 to 120 r/min with 40W motor
- Chiller reaches -10°C for efficient solvent recovery
- PTFE and fluoro rubber seals resist corrosion
- Manual bath lift adjusts 0 to 150mm height
2L Rotary Evaporator with -10°C Chiller
The HNZXIB RE201D combines a 2L rotary evaporator with a 5L circulating chiller capable of reaching -10°C. It operates on 110V/60Hz power with a US plug and is designed for laboratory solvent distillation and concentration tasks. The system includes a 2L evaporating flask with 24# conical ground joint and a 1L receiving flask.
Replaces manual distillation setups
This combination replaces separate glassware assemblies and basic cooling baths that lack precise temperature control. The integrated chiller eliminates the need for tap water or ice baths, making the jump worthwhile when consistent sub-ambient condensation improves recovery rates for heat-sensitive compounds. Digital speed control up to 120 r/min and ±1°C bath accuracy add repeatability that manual rigs cannot match.
Fits standard bench workflows
The unit requires a stable bench, vacuum source, and 110V supply; its stainless steel chassis and PTFE/fluoro rubber seals resist common solvents. Manual bath lifting over 150 mm travel accommodates various flask heights, while the double backflow condenser and 0.098 Mpa vacuum rating support efficient vapour recovery. Glassware is high borosilicate; crate packaging protects components during transit.
Highlights
- 2L evaporating flask handles up to 2000ml samples
- Digital speed control from 0 to 120 r/min with 40W motor
- Chiller reaches -10°C for efficient solvent recovery
- PTFE and fluoro rubber seals resist corrosion
- Manual bath lift adjusts 0 to 150mm height
Specifications
| Type | Rotary Evaporator |
|---|---|
| Capacity | 2L |
| Voltage | 110V |
Questions about this item
How much bench clearance does the 150 mm manual lift on the RE201D require?
The water/oil bath lifts manually through 0-150 mm, so allow at least 150 mm of vertical space above the unit for full travel.
Which sealing components must be seated before applying vacuum to reach 0.098 Mpa?
Install the PTFE and fluoro-rubber seals on the 24# conical ground joint and the double-backflow condenser before evacuation; missing either seal prevents the rated vacuum.
When should the high-borosilicate evaporating and receiving flasks be replaced?
Inspect the 2 L evaporating flask and 1 L receiving flask for chips or etching after each run; replace immediately if any damage is visible to maintain vacuum integrity.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
