HNZXIB
HNZXIB 25ml High Pressure Reactor with Pressure Gauge and Needle Valve
A 25 ml stainless-steel high-pressure reactor rated for 22 MPa and 300 °C, with a pressure gauge and needle valve for leak-tight chemical reactions
- TypePressure Reactor
- Capacity25ml
- 25 ml capacity handles small-scale reactions
- 22 MPa pressure rating supports demanding processes
- 300 °C maximum temperature enables high-heat chemistry
- Stainless steel construction resists corrosion and leakage
- Needle valve and gauge provide precise pressure control
25 ml High-Pressure Reactor
The HNZXIB vessel is a 25 ml stainless-steel reactor built for laboratory chemists who need a small, static-seal reaction chamber. Its pressure gauge and needle valve allow direct monitoring and controlled venting during experiments.
Sustained load behaviour
The reactor is rated for 22 MPa (220 bar) safety pressure and 300 °C (572 °F) operating temperature. External heating should not exceed 350 °C, with heating and cooling rates limited to 5 °C per minute to maintain seal integrity over long runs.
Interface limits
The flat cover seals through main bolts and nuts using a gasket or tapered line contact, requiring symmetrical, gradual tightening to prevent tilt. Overfilling or rapid temperature changes can compromise the static seal, so the vessel must cool naturally before opening.
Highlights
- 25 ml capacity handles small-scale reactions
- 22 MPa pressure rating supports demanding processes
- 300 °C maximum temperature enables high-heat chemistry
- Stainless steel construction resists corrosion and leakage
- Needle valve and gauge provide precise pressure control
Specifications
| Type | Pressure Reactor |
|---|---|
| Capacity | 25ml |
Questions about this item
How much heat does the 300°C reactor generate during continuous operation?
The vessel is rated for 300 °C maximum working temperature and the supplier recommends external heating not to exceed 350 °C with a heating rate of 5 °C/min.
What external equipment is required to run the 25 ml high-pressure reactor?
An external heating source capable of PID temperature control up to 350 °C, a cooling method to maintain a 5 °C/min cooldown rate, and a pressure source compatible with the 22 MPa needle valve are required.
Can the 22 MPa stainless-steel vessel be used with existing lab fittings rated for lower pressure?
The reactor uses a flat-plate flange sealed by main bolts and a gasket or metal-to-metal line contact; mating fittings must withstand 22 MPa (220 bar) to maintain the no-leakage seal.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
