We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Hitachi CP-AW252NM projector lamp module with Philips UHP 210W bulb in housing

Hitachi, Ltd.

Hitachi, Ltd. CP-AW252NM OEM Philips UHP 210W Projector Lamp 5000 Hrs

SKU CH-ST2J-0M6FE

OEM replacement lamp module with a Philips UHP 210W bulb rated for 5000 hours

  • TypeUHP
  • Wattage210W
  • Lamp Life5,000 Hrs.
  • OEM Philips UHP 210W bulb delivers reliable brightness
  • 5000-hour rated life reduces replacement frequency
  • Pre-assembled housing enables quick installation
  • ISO 9001 manufacturing ensures consistent quality
  • Compatible with Hitachi DT01181 projector models

Ready-to-Install Lamp Module

The Hitachi CP-AW252NM lamp ships as a complete bulb-and-housing assembly that fits directly into compatible Hitachi projectors without extra tools or alignment steps. It uses an original Philips UHP 210 W bulb rated for 5,000 hours of operation. The module is manufactured to ISO 9001 quality standards and arrives new in sealed packaging. Installation takes minutes and restores full brightness immediately.

Replaces Worn Original Lamps

This module replaces a dim or failed factory lamp in the same projector, eliminating colour shift and hot-spots that develop as the old bulb ages. The upgrade is worth it when image brightness drops below usable levels or when the projector warning timer reaches its limit. Each unit is tested for ignition voltage, beam uniformity and run-time before shipping. It restores the projector to its original light-output specification.

Fits Hitachi Projectors Using Part DT01181

The lamp is built for projectors that accept Hitachi part number DT01181, so verify that code in your service manual before ordering. No separate ballast or driver changes are required because the housing matches the original electrical and mechanical interface. The 210 W rating works with the projector’s existing power supply and cooling system. Keep the old module for recycling where facilities exist.

Highlights

  • OEM Philips UHP 210W bulb delivers reliable brightness
  • 5000-hour rated life reduces replacement frequency
  • Pre-assembled housing enables quick installation
  • ISO 9001 manufacturing ensures consistent quality
  • Compatible with Hitachi DT01181 projector models

Specifications

BrandHITACHI
TypeUHP
Wattage210W
Lamp Life5,000 Hrs.

Questions about this item

Does the CP-AW252NM lamp module include the housing so it fits directly into the projector?

Yes, the module is supplied as a fully assembled bulb and housing unit ready for direct installation.

What is the correct procedure for installing the DT01181 lamp and which step is most often missed?

Power off and unplug the projector, allow it to cool, remove the old lamp module, insert the new DT01181 module securely, replace the cover, then reset the lamp timer in the menu — the timer reset is the step most often missed.

When will the Philips UHP 210W bulb need replacement based on its rated life?

The bulb is rated for 5,000 hours of operation; plan replacement when the projector's lamp-hour counter approaches that figure.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.