We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Square black plastic 60mm frame cooling fan with four wires

Haywards

Haywards 60mm DC 24V 0.10A Inverter Cooling Fan video accessory

SKU CH-MFYE-63KTG

A 60 mm DC 24 V cooling fan with two-ball bearings and a 4-pin interface for inverter or computer-case airflow

  • TypeOther
  • Two-ball bearing reduces wear for 70000-hour life
  • PWM control adjusts speed to keep noise near 54 dB
  • 24 V 0.10 A input runs cool in inverter builds
  • 60 mm frame fits standard case mounts
  • CE mark confirms safety compliance for EU use

What this accessory does

This 60 mm DC cooling fan is built for inverter and video-equipment enclosures that need steady airflow. It runs on a 24 V supply drawing 0.10 A and uses a four-pin PWM interface so the host system can regulate speed automatically.

The specification that decides fit

The critical figure is the 24 V operating voltage; the fan will not start or run reliably on 12 V rails. Buyers who only have a 12 V header available cannot use this unit without a separate voltage converter.

Capacity and headroom

At full PWM duty the motor spins to 18000 RPM and moves 19.4 CFM through a 60 mm frame, which is enough for typical inverter heatsinks. Noise reaches 54 dB at that speed, so installations that require quieter operation will need to lower the PWM duty cycle or choose a larger, slower fan.

Highlights

  • Two-ball bearing reduces wear for 70000-hour life
  • PWM control adjusts speed to keep noise near 54 dB
  • 24 V 0.10 A input runs cool in inverter builds
  • 60 mm frame fits standard case mounts
  • CE mark confirms safety compliance for EU use

Specifications

TypeOther

Questions about this item

What does the 24 V 0.10 A rating mean when the fan is installed in an inverter or case?

The fan runs from a 24 V DC supply and draws 0.10 A, so it adds minimal load to the inverter or case cooling circuit.

What does the 4-pin power interface provide for this fan?

The 4-pin connector supplies power, ground, a PWM control signal and a tachometer output for speed monitoring.

Will the 60 mm frame with two-ball bearings fit standard 60 mm mounting holes?

Yes, the 60 mm square frame matches common 60 mm fan mounting patterns and the two-ball bearing design suits continuous operation.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.