Harris
Harris 45318LMPOP Safety-Silv-45 Brazing Rod 1/16x18 PK5
45 % silver brazing rod, 1/16 in diameter by 18 in long, melts between 1,225 and 1,370 °F, pack of five
- MaterialSafety-Silv-45
- TypeWelding Supplies
- 45 % silver alloy creates strong, ductile joints
- Melts between 1 225 °F and 1 370 °F for precise heat control
- AWS BAg-5 classification confirms consistent composition
- 1/16 in diameter suits fine-gap brazing work
- 18 in rod length gives comfortable handling reach
Harris Safety-Silv 45 Brazing Rod
The Harris Safety-Silv 45 brazing rod is a high-silver alloy filler metal designed for professionals and technicians performing capillary brazing on copper, steel and brass assemblies. Each rod measures 1/16 inch in diameter and 18 inches in length, supplied in a five-piece package for workshop use.
Melt range and flow behaviour
The alloy melts between 1225 and 1370 degrees Fahrenheit, providing a wide working window that resists overheating during prolonged joints. At 45 percent silver content the molten filler flows readily into tight clearances, maintaining consistent penetration and joint strength across repeated heating cycles.
Replaces lower-silver filler rods
This rod upgrades from alloys with less silver where narrow gaps or dissimilar metals cause incomplete fill or brittle joints. The jump is worthwhile when the application demands the fluidity and ductility of a BAg-5 classification, but unnecessary for simple soft-solder repairs or high-volume production using automated paste feed.
Highlights
- 45 % silver alloy creates strong, ductile joints
- Melts between 1 225 °F and 1 370 °F for precise heat control
- AWS BAg-5 classification confirms consistent composition
- 1/16 in diameter suits fine-gap brazing work
- 18 in rod length gives comfortable handling reach
Specifications
| Brand | Harris |
|---|---|
| Material | Safety-Silv-45 |
| Type | Welding Supplies |
Questions about this item
How hot does the Safety-Silv-45 rod get during a full day of brazing?
The alloy melts between 1,225 °F and 1,370 °F, so the rod and joint reach those temperatures while you work; plan ventilation and heat-resistant fixtures accordingly.
What torch setup is required to use the 1/16 in Safety-Silv-45 rods?
You need a torch that can deliver at least 1,370 °F and a tip or chuck that accepts 1/16 in bare rods; flux is also required unless the base metals are self-fluxing.
Will the 45 % silver rods flow properly on older copper fittings I already have?
Yes — BAg-5 alloy is made for copper, brass and steel, so it wets older clean copper fittings at 1,225–1,370 °F without changing your joint preparation.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
