Hakko
Hakko T9-I desoldering tweezer tip conical 0.2 mm for FM-2023 FM-203 FM-206 400 °C
Conical desoldering tweezer tip with a 0.2 mm width and 0.4 mm diameter for FM-2023 handpieces on FM-203 and FM-206 stations up to 400 °C
- TypeSolders & Supplies
- Precise SMD rework with 0.2 mm conical tip
- Fast heat-up to 400 °C for efficient desoldering
- Works with FM-2023 handpiece on FM-203 or FM-206 stations
- Durable Hakko build quality for professional use
- 4 mm outer diameter reaches tight component leads
Hakko T9-I desoldering tweezer tip 0.2 mm
The Hakko T9-I is a conical desoldering tweezer tip with a 0.2 mm width and 0.4 mm outside diameter. It fits the FM-2023 handpiece and works with FM-203 and FM-206 stations. The tip is rated for a maximum operating temperature of 400 °C.
For precision rework on dense boards
This tip suits technicians removing fine-pitch components and small surface-mount devices where narrow access is required. It is not intended for high-mass joints, large through-hole connectors or heavy ground-plane desoldering that demand broader thermal capacity.
0.2 mm conical tip width
The 0.2 mm conical tip width determines the contact area and heat delivery for fine-pitch work. Match this dimension to the component pitch and pad spacing on the assemblies you service.
Highlights
- Precise SMD rework with 0.2 mm conical tip
- Fast heat-up to 400 °C for efficient desoldering
- Works with FM-2023 handpiece on FM-203 or FM-206 stations
- Durable Hakko build quality for professional use
- 4 mm outer diameter reaches tight component leads
Specifications
| Brand | HAKKO |
|---|---|
| Type | Solders & Supplies |
Questions about this item
How does the 0.2 mm conical tip perform when removing components from a dense board?
The narrow 0.2 mm tip concentrates heat on a single lead, so you can desolder fine-pitch parts without warming neighbouring pads.
Which stations does the FM-2023 handpiece connector work with?
The tip fits the FM-2023 handpiece, which is supported by the FM-203 and FM-206 stations.
What clearance does the 0.4 mm outside diameter need in a crowded layout?
At 0.4 mm outer diameter the tweezer tips can reach between closely spaced leads on high-density assemblies.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
