Hakko
Hakko T15-J02 Soldering Tip Bent Conical 0.2mm x 3.5mm x 12mm
A 0.2 mm bent conical tip for precision soldering with Hakko FM-2027, FM-2028 and FX-950, FX-951 stations up to 840 °F
- TypeWelding Parts & Supplies
- Precise 0.2 mm point for fine-pitch work
- Bent conical shape reaches tight joints at 30°
- 4 mm tip width handles small SMD pads
- 5 mm length suits dense board layouts
- Rated to 840 °F for lead-free soldering
Precision tip for fine-pitch work
The Hakko T15-J02 is a bent conical soldering tip designed for intricate joints on dense circuit boards. Its 0.4 mm outer diameter and 30-degree bend let technicians reach tight pads without repositioning the handpiece. The tip suits repair engineers, prototype builders and hobbyists who need controlled heat on small-scale assemblies.
Thermal response and power limits
Rated for a maximum operating temperature of 840 degrees F, the tip delivers rapid heat transfer through its composite construction. The 3.5 mm tip length and 12 mm overall reach keep the working zone close to the sensor for stable regulation. Compatible stations including the FM-202, FM-203, FM-204, FM-206, FP-101, FP-102, FX-950 and FX-951 manage power draw automatically.
Station and handpiece integration
The tip locks into Hakko FM-2027 and FM-2028 handpieces without adapters, so existing T15-series users can swap tips in seconds. No additional software or calibration files are required; the station recognises the tip geometry through its built-in identification. Buyers without a compatible T15-series station or handpiece cannot use this tip.
Highlights
- Precise 0.2 mm point for fine-pitch work
- Bent conical shape reaches tight joints at 30°
- 4 mm tip width handles small SMD pads
- 5 mm length suits dense board layouts
- Rated to 840 °F for lead-free soldering
Specifications
| Brand | HAKKO |
|---|---|
| Type | Welding Parts & Supplies |
Questions about this item
How do I install the T15-J02 tip onto an FM-2027 handpiece, and what step do people often miss?
Slide the tip straight into the FM-2027 or FM-2028 handpiece until it seats fully; the step often missed is confirming the 0.4 mm outside diameter seats flush before locking the collar.
When will the T15-J02 tip need replacement under daily soldering use?
The composite tip degrades once the 0.2 mm bent-conical end erodes or the 0.4 mm shank discolours; plan replacement when wetting becomes inconsistent at 840 °F.
What is the first thermal limit reached during a long soldering session with the T15-J02?
The 840 °F maximum operating temperature is the first hard limit; sustained work at that level accelerates tip oxidation and shortens life.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
