GSM Outdoors
GSM Outdoors PL-259 UHF Male Crimp Connector 10 Pack for RG58 LMR195 RG400 3D-FB KSR195 Cable
Pack of 10 UHF male crimp connectors for RG58, RG400, LMR195, 3D-FB or KSR195 cable with gold-plated pin and nickel-plated shell
- Gold-plated pin and nickel-plated shell ensure strong conductivity and corrosion resistance
- Signal loss below .1 dB at 450 MHz with SWR under 1.15 for low-loss links
- Works with RG58, RG400, LMR195, 3D-FB and KSR195 coaxial cables
- Pack includes 10 PL259 crimp connectors plus heat-shrink tubing for quick assembly
- UHF male design mates directly with UHF female connectors
Pack of 10 UHF male crimp connectors
This pack contains ten PL-259 connectors built for RG58, RG400, LMR195, 3D-FB and KSR195 coaxial cables. Each connector uses a gold-plated copper centre pin and a nickel-plated copper shell for reliable conductivity and corrosion resistance. The included heat-shrink tubing simplifies the crimp-and-seal installation process. They are suited for RF jumper assemblies up to 450 MHz.
Installers needing quick, low-loss UHF terminations
Technicians building or repairing antenna feeds for amateur radio, CB or commercial two-way systems will appreciate the sub-0.1 dB insertion loss and SWR below 1.15 at 450 MHz. The bulk pack reduces per-connection cost for multi-site deployments. Users requiring N-type, BNC or SMA interfaces, or those working with larger-diameter cables such as LMR400, should select a different connector series.
Ten connectors handle multiple antenna runs
Ten pieces provide enough terminations for several mobile or base-station installations with spare units for field repairs. The crimp design keeps loss under 0.1 dB at 450 MHz, so signal integrity remains high across typical VHF/UHF bands. Performance degrades above the specified frequency range, and the connector body does not accommodate cables thicker than the listed RG58-class types.
Highlights
- Gold-plated pin and nickel-plated shell ensure strong conductivity and corrosion resistance
- Signal loss below .1 dB at 450 MHz with SWR under 1.15 for low-loss links
- Works with RG58, RG400, LMR195, 3D-FB and KSR195 coaxial cables
- Pack includes 10 PL259 crimp connectors plus heat-shrink tubing for quick assembly
- UHF male design mates directly with UHF female connectors
Specifications
No published specifications for this item yet.
Questions about this item
What cable types must I already have to crimp these PL-259 connectors?
These connectors are built for RG58, RG400, LMR195, 3D-FB and KSR195 coaxial cable, so you need one of those cable types on hand before you start.
Will the gold-plated centre pin and nickel-plated shell work reliably with my older UHF female bulkhead?
The copper gold-plated needle and copper nickel-plated shell give good conductivity and corrosion resistance, so they mate cleanly with existing UHF female connectors.
How can I confirm the crimped joint is performing correctly after assembly?
Expect insertion loss below 0.1 dB at 450 MHz and an SWR under 1.15; measuring those figures with a suitable analyser verifies the connection.
New to this? Buying a laptop with crypto, start to finish — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
