Graco
Graco XHD517 Airless Spray Gun Tip .017 in
Airless spray gun tip with a .017 in orifice, 10 to 12 in pattern, and 7,250 psi rating for compatible Graco XHD models
- ColorGray
- .017 in tip produces a 10 in to 12 in spray pattern for broad coverage
- Reversible design clears clogs instantly by flipping the tip
- 7,250 psi maximum working pressure handles high-demand airless spraying
- Gray colour coding identifies the .017 in orifice at a glance
- Compatible with Graco X30DH4 through X80DH4 guns for versatile use
Graco XHD517 .017 in Airless Tip
The Graco XHD517 is a reversible airless spray gun tip with a .017 in orifice. It produces a 10 in to 12 in fan pattern and uses a 7/8 in thread. The tip is rated for a maximum working pressure of 7,250 psi and comes in gray.
Thermals noise and power draw
This mechanical tip has no motor, electronics or moving parts that generate heat or noise. It adds no electrical load to the sprayer and requires no power supply of its own. Performance depends entirely on the pump and hose supplying the fluid.
Compatibility and upgrade fit
The tip fits Graco models X30DH4, X40DH4, X45DH4, X46DH4, X50DH4, X55DH4, X60DH4, X70DH4 and X80DH4 and is for use with part 288025. It replaces worn or damaged tips of the same thread and orifice size. Painters needing a different fan width or orifice diameter must select another tip.
Highlights
- .017 in tip produces a 10 in to 12 in spray pattern for broad coverage
- Reversible design clears clogs instantly by flipping the tip
- 7,250 psi maximum working pressure handles high-demand airless spraying
- Gray colour coding identifies the .017 in orifice at a glance
- Compatible with Graco X30DH4 through X80DH4 guns for versatile use
Specifications
| Brand | GRACO |
|---|---|
| Color | Gray |
Questions about this item
How do I install the Graco XHD517 tip and what step do people often miss?
Screw the tip onto the 7/8 in. thread until it seats firmly, then rotate the reversible housing to lock the spray direction; forgetting to engage the lock leaves the tip loose under 7,250 psi.
What maintenance will the .017 in tip need over time?
Soak the tip in solvent after each job to clear dried coating from the .017 in orifice, and reverse-flush daily; replace the tip when the 10 in to 12 in pattern narrows or shows heavy tails.
What limit appears first when spraying continuously at high pressure?
The 7,250 psi maximum working pressure is the ceiling; sustained operation at that level accelerates orifice wear on the .017 in tip and can overheat the pump before the gun body fails.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
