Graco
Graco XHD311 Airless Spray Gun Tip .011 in
Airless spray gun tip with a .011 in orifice, 7/8 in thread and 7,250 psi maximum working pressure
- ColorGray
- Reversible tip clears clogs quickly
- .011 in orifice delivers fine finish
- 7,250 psi rating handles high-pressure jobs
- 6–8 in fan covers broad surfaces fast
- Compatible with Graco XHD 30–80 series guns
Graco XHD311 Airless Tip .011
The Graco XHD311 is a new airless spray gun tip with a .011 inch orifice. It produces a fan pattern between six and eight inches wide. The tip threads onto compatible guns with a seven-eighths inch connection and is rated for a maximum working pressure of seven thousand two hundred fifty psi. Its gray finish identifies the tip size at a glance.
Painters needing a fine finish on low-viscosity
This tip suits applicators spraying lacquers, stains or thin coatings where a narrow .011 aperture delivers the required atomisation. The reversible feature allows the tip to be turned around to clear blockages without removing it from the gun. Contractors who need heavier film builds or wider coverage should select a larger orifice tip because this model cannot deliver higher flow rates.
The .011 inch tip size decides fit
Only a .011 inch aperture is available on this XHD311 model. If the job specification calls for a different orifice diameter this tip will not meet the requirement. Verify the required tip size against the coating manufacturer's recommendation before purchase.
Highlights
- Reversible tip clears clogs quickly
- .011 in orifice delivers fine finish
- 7,250 psi rating handles high-pressure jobs
- 6–8 in fan covers broad surfaces fast
- Compatible with Graco XHD 30–80 series guns
Specifications
| Brand | GRACO |
|---|---|
| Color | Gray |
Questions about this item
How can I confirm the Graco XHD311 tip is spraying correctly after installation?
Check that the fan pattern measures between 6 in and 8 in wide and that the gun holds up to 7,250 psi without leaks or tailing at the edges.
What comes with the Graco XHD311 tip and what must I purchase separately?
The package contains only the .011 in reversible tip; you will need a compatible Graco guard such as part 287974 and an XHD series gun (models X30DH4 through X80DH4).
Which Graco XHD tip size should I select for my project?
Choose the .011 in orifice when you need a 6 in to 8 in pattern at up to 7,250 psi; other orifice sizes in the XHD line produce different flow rates and pattern widths.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
