Goldwood Sound, Inc.
Goldwood Sound, Inc. CSic84 8" In-Ceiling Speaker 14-Pack Home Audio Speaker
Fourteen frameless in-ceiling speakers deliver three-way sound from 40 Hz to 20 kHz at 95 dB sensitivity
- TypeIn-Ceiling Speakers
- Wide sound dispersion integrates easily with any home audio system
- Passive design driven by your receiver or amplifier from 10 to 350 watts per channel
- Pressure Lock Mounting System clamps to drywall with no hardware needed
- Paintable edge-to-edge grills magnetically attach for a frameless appearance
- 3-way crossover with 8" woofer, midrange and tweeter covers 40Hz to 20kHz at 95dB
Frameless 14-speaker in-ceiling set
The Acoustic Audio by Goldwood CSic84 package delivers fourteen frameless in-ceiling speakers built for whole-home audio. Each unit uses a three-way passive design with an eight-inch poly cone woofer, Mylar midrange and half-inch Mylar tweeter. The pressure-lock mounting system clamps directly to drywall without separate hardware. Paintable magnetic grilles sit flush for a clean ceiling appearance.
95 dB sensitivity and 40 Hz–20 kHz response
At ninety-five decibels sensitivity and eight ohms nominal impedance, the speakers play loudly with modest amplifier power. The three-way crossover splits the signal cleanly across woofer, midrange and tweeter for balanced output. Frequency response extends from forty hertz to twenty kilohertz, covering the full audible range. Spring-loaded terminals accept raw speaker wire for quick, secure connections.
Requires 10–350 watts per channel
Your receiver or amplifier must supply at least ten watts and no more than three hundred fifty watts per channel into eight ohms. CL3-rated in-wall speaker wire is recommended for code-compliant runs. The speakers fit a ten-point-sixteen-inch cut-out and need four-point-six inches of mounting depth. They are not suited for buyers who need active models with built-in amplification.
Highlights
- Wide sound dispersion integrates easily with any home audio system
- Passive design driven by your receiver or amplifier from 10 to 350 watts per channel
- Pressure Lock Mounting System clamps to drywall with no hardware needed
- Paintable edge-to-edge grills magnetically attach for a frameless appearance
- 3-way crossover with 8" woofer, midrange and tweeter covers 40Hz to 20kHz at 95dB
Specifications
| Brand | Acoustic Audio by Goldwood |
|---|---|
| Type | In-Ceiling Speakers |
Questions about this item
How do I install the frameless in-ceiling speakers using the Pressure Lock Mounting System and what step is most often missed?
Cut a 10.16" round hole, ensure at least 4.06" mounting depth behind the ceiling, insert each speaker and tighten the Pressure Lock clamps until they grip the drywall firmly; the step most often missed is verifying the clamp arms have fully expanded behind the plasterboard before releasing the speaker.
What maintenance or replacement will the 3-way drivers need over time?
The 8" poly woofers use butyl rubber surrounds that resist rot, the Mylar midranges and 0.5" Mylar tweeters are durable, so under normal indoor use no scheduled driver replacement is expected; only repaint the magnetic grilles if décor changes.
What is the first limit reached when driving the 14-speaker set at high volume for long periods?
Each speaker handles 10 to 350 watts per channel and delivers 95 dB sensitivity at 8 ohms; the amplifier's per-channel power ceiling will be reached before the speakers' thermal limits, causing clipping or protection shutdown.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



