Goldwood Sound, Inc.
Goldwood Sound GW-6024 6.5" PA speaker 8-pack 170W 4ohm
Eight 6.5-inch woofers deliver 90 watts RMS each with 4-ohm impedance for PA systems
- TypeSpeaker
- Eight woofers deliver scalable PA coverage for venues
- 170 W max power per driver handles demanding live sound
- 90 W RMS rating sustains clean output through long sets
- 89 dB SPL sensitivity reduces amplifier headroom requirements
- 29–4800 Hz response covers vocals and instruments evenly
Eight-piece professional woofer kit
This pack contains eight Goldwood Sound GW-6024 woofers built for PA, DJ, karaoke, live-sound, fixed-installation, studio-monitor and home-audio use. Each driver is new and engineered in the USA with a stamped steel frame, 20 oz magnet, bumper plate and vented pole piece. The butyl rubber surround and poly mica cone are designed for long-term durability in touring or installed systems.
4 ohm nominal impedance
Every woofer presents a 4 ohm load, so the amplifier or crossover must be stable at that impedance across the full 29 to 4800 Hz range. Wiring multiple units in parallel will reduce the total load further and can trigger protection circuits on amplifiers not rated for lower impedances. Builders who need an 8 ohm load or a different impedance curve should look elsewhere.
90 watts RMS continuous handling
The 90 watt RMS rating reflects sustained thermal capacity with the 1.5 inch aluminum voice coil and vented pole piece dissipating heat during extended sets. The 170 watt maximum figure applies only to short peaks, not continuous programme material. Systems driven at high average levels for hours at a time should be designed around the RMS figure to avoid thermal compression or coil damage.
Highlights
- Eight woofers deliver scalable PA coverage for venues
- 170 W max power per driver handles demanding live sound
- 90 W RMS rating sustains clean output through long sets
- 89 dB SPL sensitivity reduces amplifier headroom requirements
- 29–4800 Hz response covers vocals and instruments evenly
Specifications
| Brand | Goldwood |
|---|---|
| Type | Speaker |
Questions about this item
How loud will one of these 170 W woofers actually get in a cabinet?
Each woofer reaches 89 dB SPL at one watt, so with 170 W peak power the output rises well above that level in a typical enclosure.
Does the 4 ohm rating limit which amplifiers I can use?
The 4 ohm impedance means you need an amp rated for 4 ohm loads; many PA and DJ amps handle it, but check your amp’s minimum impedance spec first.
Will these 6.5 inch drivers fit the cut-outs in my existing speaker boxes?
They require a 5.71 inch mounting hole and 3.01 inch depth, so measure your cabinet cut-out and internal clearance before ordering.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



