Goldwood Sound, Inc.
Goldwood Sound GW-208/8 8" woofers 200 W 8 ohm pa speaker 6 pack
Six 8-inch PA woofers rated 100 watts RMS with 45–7000 Hz response and 88 dB sensitivity
- TypeSpeaker
- Handles loud passages cleanly with 200 W peak power
- Deep bass foundation starts at 45 Hz response
- Efficient 88 dB sensitivity reduces amplifier strain
- Six matched drivers simplify multi-cabinet array builds
- USA-engineered design ensures consistent pro-audio reliability
Six-piece woofer kit
This pack contains six Goldwood Sound GW-208/8 woofers built for professional PA, DJ, karaoke, live-sound, fixed-installation, studio-monitor and home-audio cabinets. Each driver handles 100 watts RMS and 200 watts maximum power at an 8-ohm load. The eight-inch cone diameter suits standard replacement cut-outs.
Stamped steel frame and vented pole piece
A 1.5-inch aluminum voice coil rides on a 20-ounce magnet with bumper plates and a vented pole piece for heat dissipation. Poly-laminated cones with rolled foam surrounds resist moisture and fatigue. The frame mounts in a 7.2-inch hole and requires 3.36 inches of depth behind the baffle.
Direct replacement for blown eight-inch drivers
The woofers restore output in cabinets originally fitted with similar 45-to-7000-hertz, 88-dB sensitivity units. The upgrade is worthwhile when the original cones are torn, surrounds have rotted or voice coils have overheated. Buyers needing higher power handling, lower frequency extension or different impedance should look elsewhere.
Highlights
- Handles loud passages cleanly with 200 W peak power
- Deep bass foundation starts at 45 Hz response
- Efficient 88 dB sensitivity reduces amplifier strain
- Six matched drivers simplify multi-cabinet array builds
- USA-engineered design ensures consistent pro-audio reliability
Specifications
| Brand | Goldwood |
|---|---|
| Type | Speaker |
Questions about this item
What impedance does the GW-208/8 woofer present to an amplifier?
Each woofer has an 8 ohm nominal impedance, so six in parallel would drop the load considerably.
What cut-out diameter and mounting depth are required for the GW-208/8?
The frame needs a 7.2 inch enclosure hole and 3.36 inches of clearance behind the baffle.
How are the GW-208/8 woofers connected and what polarity mistake should be avoided?
Wire each 8 ohm driver to the amplifier terminals, observing the marked positive and negative to keep all cones moving in phase.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



