Funnel King
Funnel King 32140 1-1/2 qt 14" 6" 1" Green funnel
A 1-1/2 qt polyethylene funnel with 14 in length and 6 in spout for fluid transfer
- 1-1/2 qt capacity handles large fluid volumes
- 14 inch length reaches deep fill points
- 6 inch diameter prevents splash-back
- 1 inch spout fits standard openings
- Double capped design seals during storage
Product Identity
The Funnel King 32140 is a 1-1/2 quart polyethylene funnel coloured green. It measures 14 inches in overall length with a 6 inch bowl diameter and a 1 inch spout. The double-capped design keeps debris out when the funnel is stored. It suits automotive fluid changes and general garage tasks.
Thermals Noise Power
This funnel has no electrical components so it produces no heat, no noise and draws no power. It operates passively during pouring and sits inert on a shelf between uses. The polyethylene body resists common automotive fluids without degrading.
Compliance Note
California Proposition 65 warnings apply because the product contains a chemical known to the state to cause cancer and birth defects or other reproductive harm. Buyers who require a funnel without such a warning should choose a different product.
Highlights
- 1-1/2 qt capacity handles large fluid volumes
- 14 inch length reaches deep fill points
- 6 inch diameter prevents splash-back
- 1 inch spout fits standard openings
- Double capped design seals during storage
Specifications
| Brand | FUNNEL KING |
|---|
Questions about this item
How do I install the 14" funnel so it won't spill when pouring 1-1/2 qt of fluid?
Place the 1" outlet fully into the target opening, hold the 6" wide body steady with one hand, and pour slowly to let air escape; the double caps seal after use.
What maintenance or replacement will the polyethylene funnel need later?
Rinse with compatible solvent after each use, inspect the 1" tip and caps for cracks or chemical swelling, and replace the unit if the green body shows brittleness or permanent deformation.
What limit shows up first when using the funnel continuously for hot fluids?
The polyethylene body softens near its heat-deflection point, so prolonged exposure to very hot liquids will cause the 14" spout to sag before any other part fails.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
