Fulterer USA
Fulterer USA FL.FR5400.L.32 32 in Heavy-Duty Full Extension Side Mount Metal hardware
A 32-inch heavy-duty drawer slide provides full-extension travel with a locking mechanism that works in lock-in or lock-out mode depending on orientation
- TypeCabinet & Drawer Hardware
- Full extension access with 32 in travel
- Heavy-duty construction meets ANSI/BIFMA 5.5-2008
- Lock-in or lock-out mode by orientation
- Certified for NSF/ANSI 2 food equipment use
- Lever protrudes 35 mm beyond slide length
32 in Heavy-Duty Drawer Slide
This Fulterer side-mount slide provides full extension travel for drawers up to 32 inches long. It is built for industrial and commercial cabinetry where heavy loads and frequent cycling are expected. The steel construction meets multiple ANSI, KCMA and NSF standards for durability and food-service safety. Lock-in and lock-out modes are selectable by reversing the left and right members.
Installers needing full access to deep drawers
The slide suits RV compartments, fire-truck storage, ambulance cabinets, toolboxes and utility trailers where the drawer must travel the full length of the cabinet. It is not intended for light-duty residential drawers that do not require full extension or locking features. Buyers who need undermount or soft-close action should consider a different slide type. The lock lever adds 35 mm beyond the slide length, so verify clearance before ordering.
32 inch travel with locking headroom
The 32 inch slide length gives complete drawer access while the locking mechanism secures the drawer open or closed depending on orientation. Load capacity and cycle ratings are validated to ANSI/BIFMA X 5.5-2008, ANSI/KCMA A 161.1-2006 and SEFA-8-2007 standards. The 3/4 inch side clearance and protruding lever define the installation envelope; ensure the cabinet opening accommodates both dimensions.
Highlights
- Full extension access with 32 in travel
- Heavy-duty construction meets ANSI/BIFMA 5.5-2008
- Lock-in or lock-out mode by orientation
- Certified for NSF/ANSI 2 food equipment use
- Lever protrudes 35 mm beyond slide length
Specifications
| Brand | FULTERER |
|---|---|
| Type | Cabinet & Drawer Hardware |
Questions about this item
What cabinet depth do I need for the 32 in Fulterer FR5400 slide to fit?
The slide itself is 32 in long and the lock lever protrudes an extra 35 mm beyond that, so allow at least 32 in plus 1-3/8 in of cabinet depth.
Can I pair these 5400 series slides with older Fulterer hardware that meets ANSI/BIFMA X 5.5-2008?
Yes, the FR5400 is tested to ANSI/BIFMA X 5.5-2008 and other listed standards, so it will perform consistently with earlier slides certified to the same specs.
How do I verify the lock-in and lock-out functions are working after installation?
Extend the drawer fully — it should click and hold in the open position; push to release, then close — it should click and hold shut; reversing the left and right slides swaps the two modes.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
