FREUD
Freud 6.5in 24T Diablo Circular Saw Blade D0624A 10pk
6.5-inch 24-tooth framing blade pack of 10 with thin kerf and non-stick coating
- TypeCircular Saws
- Super-thin laser-cut kerf speeds up cuts
- Perms-SHIELD non-stick coating reduces blade drag
- Tri-metal shock-resistant brazing protects carbide tips
- TiCo Hi-density Carbide extends cutting life
- 10 000 RPM maximum suits high-speed saws
Framing blade pack
This pack contains ten Freud Diablo circular saw blades built for framing work. Each blade measures 6.5 inches in diameter with 24 teeth and a 63-inch arbor. The super-thin laser-cut kerf and Perms-SHIELD non-stick coating reduce drag and material buildup during repetitive cuts. Tri-metal shock-resistant brazing and TiCo high-density carbide extend tooth life on tough lumber.
Installation notes
The 63-inch arbor fits standard framing saws that accept a 6.5-inch blade, so mounting is straightforward. Laser-cut heat expansion slots help the plate stay true under load, minimising wobble that can cause binding. The thin kerf removes less material, which lowers the feed force required, but it also means the blade can deflect if pushed too hard on dense knots. Always verify the saw’s maximum RPM rating before fitting.
10 000 RPM limit
The single figure that decides suitability is the 10 000 maximum RPM rating. Any saw that spins faster than this limit makes the blade unsafe to use. Builders running high-speed worm-drive or hypoid saws above 10 000 RPM must choose a different blade. Users needing a finer finish for trim or sheet goods will also want a higher tooth count than the 24 provided here.
Highlights
- Super-thin laser-cut kerf speeds up cuts
- Perms-SHIELD non-stick coating reduces blade drag
- Tri-metal shock-resistant brazing protects carbide tips
- TiCo Hi-density Carbide extends cutting life
- 10 000 RPM maximum suits high-speed saws
Specifications
| Type | Circular Saws |
|---|
Questions about this item
How do I confirm the blade runs true after mounting it on a 63 arbor?
Spin the blade at low speed and watch the kerf track a straight line in scrap lumber; a steady cut with no wobble shows it is running true.
What comes in the pack and what must I supply myself?
The box contains ten 6.5 inch 24-tooth Diablo framing blades; you must provide a compatible circular saw with a 63 arbor.
Which version should I choose for general framing?
The D0624A 10-pack with 6.5 inch diameter, 24 teeth and super-thin kerf is the only version listed for framing work.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
