Freeman
Freeman PDX50C 3-in-1 15.5/16 Gauge 2 in. Flooring Nailer/Stapler Cordless
Cordless 3-in-1 flooring nailer and stapler drives 15.5 and 16-gauge fasteners up to 2 inches with interchangeable base plates and no-mar tip
- TypeCombo Kits
- CordlessCordless
- Cordless operation removes hose and compressor hassle
- 3-in-1 versatility drives 16-gauge cleats and 15.5-gauge staples
- One-piece hardened drive blade withstands all-day use
- 20% lighter build reduces fatigue on big jobs
- No-mar base protects prefinished floors from scratches
Freeman PDX50C cordless flooring nailer
The Freeman PDX50C is a cordless 3-in-1 tool that drives 15.5-gauge staples and 16-gauge T-cleats or L-cleats up to two inches long. It targets installers who want a single device for solid tongue-and-groove hardwood floors without the hose and compressor of pneumatic units. The no-mar base protects prefinished surfaces during every strike.
Sustained-use behaviour
A one-piece hardened steel drive blade and aluminium cylinder resist wear during full-day installation runs. An internal air filter and anti-dust cap keep debris out of the mechanism so performance stays consistent across thousands of cycles. The tool is 20% lighter than comparable flooring nailers, reducing operator fatigue on large jobs.
Pre-purchase checks
Verify that your flooring specification calls for 15.5-gauge staples or 16-gauge cleats, as the magazines do not accept other fastener sizes. Confirm you have a compatible battery platform and charger, because the cordless motor requires Freeman power packs that are sold separately. Ensure the work area allows enough swing clearance for the long-reach fiberglass mallet.
Highlights
- Cordless operation removes hose and compressor hassle
- 3-in-1 versatility drives 16-gauge cleats and 15.5-gauge staples
- One-piece hardened drive blade withstands all-day use
- 20% lighter build reduces fatigue on big jobs
- No-mar base protects prefinished floors from scratches
Specifications
| Type | Combo Kits |
|---|---|
| Cordless | Cordless |
Questions about this item
How much vibration and heat does the Freeman PDX50C produce during all-day flooring installation?
The one-piece hardened-steel drive blade and aluminium cylinder are built for continuous daily use, while the internal air filter keeps debris out so the tool runs cleanly over long shifts.
What power source and fasteners must I already have to operate this 3-in-1 nailer?
It is a cordless tool that accepts 16-gauge T-cleats, 16-gauge L-cleats and 15.5-gauge flooring staples, so you need compatible fuel cells and the correct cleats or staples for your floor type.
Will the interchangeable base plates and no-mar tip work safely on my existing prefinished tongue-and-groove boards?
Yes, the no-mar design protects prefinished surfaces and the swappable base plates adapt to solid tongue-and-groove hardwood, letting you keep the flooring you already have.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
