Festo
Festo VUVG-S18-T32C-AZT-G14-1T1L 18mm 24V DC 900 l/min G1/4 IP65 IP67 electrician tool
18 mm 24 V DC piston gate valve delivers 900 l/min flow with IP65 IP67 protection and LED status display
- TypeTest Equipment
- Color/FinishRed
- Item Count1 pack
- Selling UnitBox
- Parts3 Years
- Labor1 Year
- Fast switching with 15 ms on and 34 ms off times
- High flow capacity of 900 l/min through G1/4 port
- Reliable operation from -5 °C to 60 °C ambient
- Protected against dust and water jets with IP65 and IP67
- Low power consumption at 1.0 W with 24 V DC coil
Festo 18 mm 24 V DC solenoid valve
The Festo VUVG-S18-T32C-AZT-G14-1T1L is a pilot-controlled piston gate valve with a 2x3/2 closed monostable function. It delivers a standard nominal flow rate of 900 l/min through G1/4 pneumatic ports while operating on 24 V DC with a 1.0 W coil. The valve achieves IP65 and IP67 protection and weighs 145 g.
Suits pneumatic automation needing dual 3/2 control
This unit fits machines that require two independent normally-closed 3/2 valves in an 18 mm body with external pilot supply and flow-control exhaust. It is not for systems that need a single 5/2 or 5/3 valve, internal pilot air, or a larger flow path beyond the stated 900 l/min rating.
Check pressure, voltage
Verify the main supply provides 1.5 to 10 bar and the external pilot line delivers 1.5 to 8 bar with compressed air meeting ISO 8573-1:2010 [7:4:4]. Confirm the 24 V DC source stays within +/- 10 % and that the 15 ms on / 34 ms off switching times meet cycle requirements. The operating temperature range spans -5 °C to 60 °C.
Highlights
- Fast switching with 15 ms on and 34 ms off times
- High flow capacity of 900 l/min through G1/4 port
- Reliable operation from -5 °C to 60 °C ambient
- Protected against dust and water jets with IP65 and IP67
- Low power consumption at 1.0 W with 24 V DC coil
Specifications
| Brand | FESTO |
|---|---|
| Model | VUVG-S18-T32C-AZT-G14-1T1L 8004873 |
| Type | Test Equipment |
| Color/Finish | Red |
| Item Count | 1 pack |
| Selling Unit | Box |
| Parts | 3 Years |
| Labor | 1 Year |
Questions about this item
What pneumatic supply and pilot pressure must I already have for the 18 mm valve to operate?
You need a compressed-air supply at 1.5 to 10 bar for the main circuit and an external pilot supply at 1.5 to 8 bar, both meeting ISO 8573-1:2010 [7:4:4] quality.
Will the G1/4 ports on this 900 l/min valve thread directly into my existing G1/4 fittings?
Yes, the working ports are G1/4 so they match standard G1/4 pneumatic fittings without adapters.
How can I confirm the 24 V DC solenoid is switching correctly after installation?
The built-in LED shows signal status, and you should measure 15 ms on-time and 34 ms off-time at the 3 Hz maximum switching frequency.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
