Fans
Fans G1G170-AB53-01 170mm 360W 5830 RPM centrifugal blower
A 170 mm EC centrifugal blower delivering 360 W at 5830 RPM for gas-condensing heating systems
- 170 mm diameter fits tight enclosures
- 360 W input delivers strong airflow
- 5830 RPM speed moves air efficiently
- 25 °C to 55 °C ambient range suits harsh sites
- EC motor cuts energy use and noise
G1G170-AB53-01 centrifugal blower
This 170 mm EC centrifugal blower delivers 360 W at 5830 min-1 for gas-condensing heating systems. The single-inlet, backward-curved impeller with flange housing is built for continuous airflow in HVAC installations. It suits engineers and installers specifying original ebm-papst components for new builds or direct replacements.
Check voltage phase and ambient limits before
The motor runs on 1~ 230 VAC at 50/60 Hz and draws 1.6 A at full load. Verify that your supply matches this single-phase rating and that the installation ambient stays between -25 °C and 55 °C. The flow medium must not exceed 80 °C. Confirm the flange mounting pattern matches your existing ductwork.
Integrated EC electronics enable 100 % speed control
The built-in EC motor accepts analog or serial interface signals for stepless 0–100 % speed regulation without external drives. Plug-and-play start-up uses matched open-loop control components for immediate operation. Low energy consumption and maintenance-free design reduce operating cost over the service life.
Highlights
- 170 mm diameter fits tight enclosures
- 360 W input delivers strong airflow
- 5830 RPM speed moves air efficiently
- 25 °C to 55 °C ambient range suits harsh sites
- EC motor cuts energy use and noise
Specifications
No published specifications for this item yet.
Questions about this item
Does the G1G170-AB53-01 blower ship with a power cable or mounting hardware, or must those be sourced separately?
The supplier lists only the centrifugal blower with integrated housing and flange; no cable, connector or mounting kit is mentioned, so plan to supply your own wiring and fixings.
The spec shows 230 VAC, 50/60 Hz, 360 W and 5830 min⁻¹ — is this the only voltage-speed combination available for this model?
The data sheet provides a single nominal voltage of 230 VAC at 50/60 Hz with a fixed speed of 5830 min⁻¹; no alternative voltage or speed variants are documented for the G1G170-AB53-01.
With a 360 W power draw and 5830 min⁻¹ rated speed, what airflow can I expect once the blower is installed in a duct system?
The manufacturer cites a maximum airflow of 35,000 m³/h for the fan series; actual installed flow will depend on duct resistance, inlet conditions and the 170 mm flange interface.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
