Fans
Fans D4D180-CB01-02 centrifugal blower
Three-phase centrifugal blower runs on 230 or 400 VAC at 50 or 60 Hz, delivering 1050 rpm with IP44 motor protection
- IP44 motor and sealed design protect against dust and moisture
- Forward-curved blades on double inlet move more air in a compact housing
- Galvanised steel body riveted for strength and long service life
- Ball bearings allow installation in any orientation without wear penalty
- Three-phase 230 V or 400 V operation covers 50 Hz and 60 Hz supplies
Centrifugal Blower D4D180-CB01-02
This AC double-inlet centrifugal blower uses an external-rotor motor in a riveted galvanised-steel housing. It runs on three-phase supply at 230 VAC or 400 VAC, 50 Hz or 60 Hz, drawing 0.92 A at 230 V 50 Hz and 0.53 A at 400 V 50 Hz. The motor is IP44 rated, Class B insulated and permanently sealed for maintenance-free operation.
Suited for industrial HVAC
The blower suits installations that can provide three-phase power and need a compact, rugged airflow source with forward-curved blades. It is not for single-phase mains supplies, nor for buyers who need variable-speed control without an external drive, or who require a higher static-pressure rating than the published zero minimum back-pressure figure.
Mounts in any orientation with ball-bearing motor
The permanently sealed ball bearings allow horizontal, vertical or angled mounting without lubrication schedules. Both volute openings are accessible for duct connection, which simplifies routing in tight cabinets. The unit needs a three-phase supply and a motor-protection circuit to avoid overload, freeing the builder from brush wear and belt maintenance.
Highlights
- IP44 motor and sealed design protect against dust and moisture
- Forward-curved blades on double inlet move more air in a compact housing
- Galvanised steel body riveted for strength and long service life
- Ball bearings allow installation in any orientation without wear penalty
- Three-phase 230 V or 400 V operation covers 50 Hz and 60 Hz supplies
Specifications
No published specifications for this item yet.
Questions about this item
What three-phase supply does the D4D180-CB01-02 need to run?
The blower operates on three-phase AC at either 230 V or 400 V, 50 Hz or 60 Hz, drawing 0.92 A at 230 V 50 Hz and 0.53 A at 400 V 50 Hz.
Will the blower fit in the same mounting points as an older single-inlet unit I keep?
This model is a double-inlet centrifugal blower with a riveted galvanised-steel housing; mounting hole spacing differs from single-inlet units, so new brackets or an adapter plate will be required.
How can I confirm the motor is running at the rated speed after wiring it up?
Measure the shaft speed with a tachometer; it should read 1050 min⁻¹ at 50 Hz or 1030 min⁻¹ at 60 Hz when the supply voltage matches the nameplate.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
