Everflow Supplies Inc.
Everflow Supplies Inc. C65-14-NL 1/4 O.D. COMP 90 Degree Elbow Pipe Fitting
Connects two 1/4-inch pipes at a 90-degree angle using lead-free brass compression fittings for leak-free plumbing
- 90-degree elbow joins pipes at right angles
- 1/4 inch compression size fits standard tubing
- Lead-free brass construction resists corrosion and rust
- Creates secure compression bond preventing water leaks
- Suitable for commercial and residential plumbing systems
1/4 O.D. Compression Elbow
This lead-free brass elbow joins two compression pipes at a 90 degree angle. It creates a secure compression bond that prevents water leakage. The fitting suits both commercial and residential plumbing systems. Buyers who need a straight coupling or a different pipe diameter cannot use this part.
Lead-Free Brass Construction
Solid brass resists rust and corrosion across a wide range of applications. The lead-free alloy meets modern plumbing material requirements. Installers should wash hands after handling because the product carries a Proposition 65 warning for lead exposure. The 90 degree bend simplifies routing in tight spaces.
Proposition 65 Compliance Included
California warnings for cancer and reproductive harm are supplied with the fitting. This documentation helps contractors meet regulatory obligations on job sites. No additional seals, ferrules or tools are bundled with the elbow. Installers must provide compatible compression nuts and sleeves separately.
Highlights
- 90-degree elbow joins pipes at right angles
- 1/4 inch compression size fits standard tubing
- Lead-free brass construction resists corrosion and rust
- Creates secure compression bond preventing water leaks
- Suitable for commercial and residential plumbing systems
Specifications
| Brand | EVERFLOW |
|---|
Questions about this item
What pipe size does the 1/4 O.D. compression interface on this elbow fitting accept?
The 1/4 O.D. compression interface accepts 1/4 inch outside-diameter tubing for a secure joint.
What physical space is needed to mount this 90 degree elbow in a compression piping system?
The fitting creates a right-angle turn between two pipes, so allow clearance for the 90 degree bend and the compression nuts on each end.
How is the compression seal made when installing this lead-free brass elbow, and what step is often missed?
Slide the nut and ferrule onto the tube, insert the tube fully into the fitting, then tighten the nut to compress the ferrule; the step often missed is fully seating the tube before tightening.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
