Everflow Supplies Inc.
Everflow Supplies Inc. 5710 Stainless Steel Worm Drive Hose Clamps 10 pack
A pack of ten stainless-steel worm-drive clamps covering 1/2 to 1-1/16 inch diameters for automotive, plumbing and mechanical use
- 300-grade stainless steel resists corrosion and rust
- Adjustable 1/2" to 1-1/16" range fits multiple hose sizes
- Worm-drive mechanism locks securely under high pressure
- Tighten easily with hex wrench or flat screwdriver
- Ten clamps per pack cover several connections
Ten-piece stainless clamp set
This pack contains ten worm-drive hose clamps made from 300 grade stainless steel with zinc-plated screws. The adjustable bands cover diameters from one-half inch to one and one-sixteenth inch, fitting one size smaller or larger than the nominal range. They are suited for automotive repairs, household plumbing and general mechanical projects where corrosion resistance matters.
Corrosion resistance and tightening
The stainless construction resists rust, sun exposure and most chemicals across a wide temperature range from cold to intense heat. A high-torque worm gear locks securely and stays tight on high-pressure hose. Each clamp can be tightened with a hex wrench or flat screwdriver for a firm seal.
Replaces worn or mild-steel clamps
These clamps upgrade from corroded, stripped or undersized fasteners that leak under pressure or vibration. The jump is worth it when a durable, reusable clamp is needed for repeated service in harsh environments. Buyers who need a different diameter range or a single-unit purchase should look elsewhere.
Highlights
- 300-grade stainless steel resists corrosion and rust
- Adjustable 1/2" to 1-1/16" range fits multiple hose sizes
- Worm-drive mechanism locks securely under high pressure
- Tighten easily with hex wrench or flat screwdriver
- Ten clamps per pack cover several connections
Specifications
| Brand | EVERFLOW |
|---|
Questions about this item
How do I install the 5710 worm-drive clamps and which step is often missed?
Slip the band over the hose, position it past the barb, then tighten the zinc-plated screw with a hex wrench or flat screwdriver; the step many skip is checking that the band sits flat against the hose all the way around before final torque.
What maintenance or replacement will these 300-grade stainless clamps need later?
Inspect the band and screw for corrosion or thread wear after each heating-cooling cycle; replace any clamp that no longer holds the hose securely or shows pitting on the stainless surface.
What limit appears first when the clamps are under sustained high-pressure use?
The worm-gear locking mechanism reaches its maximum clamping force before the 300-grade stainless band yields, so over-tightening can strip the screw threads and lose seal integrity.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
