Everflow Supplies Inc.
Everflow Supplies Inc. 53341-NL SWT Ball Valve Long Bonnet T-Handle Brass 3/4
A premium brass ball valve with chrome plated ball, SWT connections, vinyl T-handle and long bonnet for hard-to-reach access
- Chrome-plated ball resists corrosion for reliable sealing
- Sweat connections create permanent leak-free joints
- Vinyl T-handle gives comfortable grip and easy operation
- Long bonnet design reaches valves in tight spaces
- Lead-free brass construction meets California Proposition 65 standards
Premium Brass Ball Valve
The Everflow 53341-NL SWT ball valve controls water flow in residential and light-commercial piping. Its chrome-plated ball and vinyl T-handle give reliable shut-off and easy quarter-turn operation. The long bonnet design reaches fittings tucked behind walls or insulation. Installers who need a straight-through bronze or stainless alternative should look elsewhere.
Replaces Standard Bonnet Valves
Swap out a short-bonnet valve when the handle sits too close to the pipe for comfortable grip or when insulation blocks access. The extended bonnet clears extra lagging without re-piping. If the system demands press-fit or threaded ends instead of sweat connections, this model will not fit.
Straightforward Sweat Installation
Clean the copper tube, apply flux, and solder the SWT ends in the usual way; the long bonnet keeps the stem packing away from direct heat. Overheating the joint can damage the vinyl T-handle, so wrap it with a wet cloth while soldering. Verify local code acceptance for brass ball valves before closing up the wall.
Highlights
- Chrome-plated ball resists corrosion for reliable sealing
- Sweat connections create permanent leak-free joints
- Vinyl T-handle gives comfortable grip and easy operation
- Long bonnet design reaches valves in tight spaces
- Lead-free brass construction meets California Proposition 65 standards
Specifications
| Brand | EVERFLOW |
|---|
Questions about this item
What pipe size and connection type does the 3/4" SWT valve require?
The valve uses 3/4 inch sweat (SWT) connections, so it solders directly onto 3/4 inch copper tubing.
How is the long-bonnet T-handle valve installed, and what step is often missed?
Clean and flux the copper pipe ends, slide the valve on, then solder each joint; the step often missed is fully opening the T-handle before heating so the ball does not seize.
What maintenance or replacement will the chrome-plated ball and vinyl T-handle need later?
Exercise the handle quarterly to prevent sticking; replace the valve if the ball shows pitting or the vinyl handle cracks from heat or age.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
