Estry
Estry MJR-7000EZ Ni-MH 3.6V 700mAh standard battery
Ni-MH 3.6V 700mAh replacement battery fits Amano MJR-7000EZ, MJR-8000N and Stromberg SJX-8000 time clocks
- Specifications3.6
- Battery Pack1 Year
- Exact-fit replacement for Amano and Stromberg time clocks
- Ni-MH 3.6V 700mAh chemistry delivers 2.52Wh reliable power
- Built-in overcharge, over-discharge and short-circuit protection
- Certified to ISO 9001, RoHS, CE and UN 38.3 safety standards
- Compact 50.0 x 43.5 x 14.5 mm pack weighs 105.0g
Direct replacement battery
The Estry MJR-7000EZ is a Ni-MH cell rated at 3.6V and 700mAh, built to match the original specifications for Amano and Stromberg time-recording terminals. It fits models including the MJR-7000EZ, MJR-8000N, MJR810, SJX-8000, MJR-7000 and MJR-BIO Biometric Totalizer units.
Restores clock and data retention
This pack replaces the original IR430850 or EBA-233301 battery when the terminal loses its clock setting or stored records after a power loss. The jump is worth it whenever the existing cell no longer holds a charge, which typically appears as repeated time resets or missing punch data on the listed devices.
Simple two-wire swap
Installation requires opening the terminal case, unplugging the old pack and connecting the new one using the existing connector; the pack measures 50.0 x 43.5 x 14.5mm and weighs 105.0g. Problems usually arise if the part number is not verified against the label inside the unit, leading to a mismatch with the terminal's charging circuit.
Highlights
- Exact-fit replacement for Amano and Stromberg time clocks
- Ni-MH 3.6V 700mAh chemistry delivers 2.52Wh reliable power
- Built-in overcharge, over-discharge and short-circuit protection
- Certified to ISO 9001, RoHS, CE and UN 38.3 safety standards
- Compact 50.0 x 43.5 x 14.5 mm pack weighs 105.0g
Specifications
| Brand | Ni-MH |
|---|---|
| Model | 700mAh |
| Specifications | 3.6 |
| Battery Pack | 1 Year |
Questions about this item
Will the 50.0 x 43.5 x 14.5 mm pack fit my MJR-8000 unit?
Yes, the dimensions match the original IR430850 and EBA-233301 cells used in the MJR-8000 series.
How do I install the pack without damaging the connector?
Align the red and black leads to the board header, press straight in until the latch clicks, then route the wires away from the case edge.
When should I replace this 700 mAh Ni-MH cell?
Plan a swap after roughly one year or when the time clock loses its setting during a power cut.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



