We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Ergodyne 3700 orange webbed nylon tool tail with steel D-ring

Ergodyne

Ergodyne 3700 Web Tool Tails 4 1/2 in Orange traffic safety equipment

SKU CH-ZNAS-1FD7B

A 4 1/2-inch orange webbed nylon tether strap with a steel D-ring rated to 2 lb, compliant with ANSI/ISEA 121-2018 for securing hand tools

  • ColorOrange
  • ANSI/ISEA 121-2018 compliant for drops prevention
  • Steel D-ring rated for 2 lb tool capacity
  • Webbed nylon strap resists abrasion and wear
  • Tape-on attachment fits shafts without drilling
  • High-visibility orange improves on-site tool spotting

Ergodyne 3700 Tool Tail

This Ergodyne Squids 3700 web tool tail creates a secure tether point for hand tools up to 2 lb. The 4 1/2 in orange webbed nylon strap wraps around a shaft and fastens with tape for a fixed connection. A single steel D-ring provides the attachment point for a tool lanyard. It meets ANSI/ISEA 121-2018 requirements for dropped-object prevention.

Who Should Use This

Workers securing lightweight hand tools at height will find this attachment point simple and compliant. It suits shafts where a slip-on loop and tape closure can hold. Buyers needing higher weight ratings, integrated tool-specific holders, or permanent bolt-on anchors should look at other tethering hardware.

Deciding Specification

The 2 lb weight capacity is the critical limit. Verify every tool and accessory stays at or below this figure before relying on the tail for fall protection. Exceeding the rated capacity voids compliance with the cited standard.

Highlights

  • ANSI/ISEA 121-2018 compliant for drops prevention
  • Steel D-ring rated for 2 lb tool capacity
  • Webbed nylon strap resists abrasion and wear
  • Tape-on attachment fits shafts without drilling
  • High-visibility orange improves on-site tool spotting

Specifications

ColorOrange
BrandErgodyne

Questions about this item

Does the steel D-ring on the 3700 Web Tool Tail add noticeable weight or heat when worn all day?

The tether weighs only 2 lb total, so the steel D-ring contributes minimal weight and generates no heat during extended use.

What must I already own to attach this Squids series tether to my hand tools?

You need hand tools with shafts that accept a tape-on strap; the tether wraps directly around the tool handle.

Will the ANSI/ISEA 121-2018 rated D-ring work with older fall-protection lanyards I already use?

Yes, the steel D-ring conforms to ANSI/ISEA 121-2018, so it connects reliably to existing compliant lanyards and carabiners.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.