Electronix Express
Electronix Express 2 Pack 1mm Conical Soldering Tips ZD-931
Two 1 mm conical tips for the ZD-931 soldering station, each measuring 2.59" x .27" x .27"
- TypeSoldering Tips
- Two tips included for uninterrupted workflow
- 1 mm conical shape enables fine-detail soldering
- Designed for ZD-931 station so heat transfer stays consistent
- Compact 2.59" length fits tight board spacing
- New condition guarantees full tip life from first use
2 Pack 1 mm Conical Tips
This two-pack supplies replacement conical tips with a 1 mm point for the Electronix Express ZD-931 soldering station. They are intended for hobbyists, repair technicians and students who need a fine tip for precision joints on small components. The tips are new and ready for immediate use.
Compatibility with ZD-931 station
The tips are manufactured to fit the RSR / Electronix Express ZD-931 soldering station (0603ZD931) without adapters. Using the correct tip geometry restores the station’s original heat transfer characteristics and tip-to-work distance. No additional software or accessories are included in the pack.
Simple drop-in installation
Installation consists of loosening the station’s retaining nut, removing the worn tip and seating the new conical tip before re-tightening. The 2.59" length matches the original specification so the handle balance does not change. The most common issue is cross-threading the nut if it is forced; gentle alignment avoids this.
Highlights
- Two tips included for uninterrupted workflow
- 1 mm conical shape enables fine-detail soldering
- Designed for ZD-931 station so heat transfer stays consistent
- Compact 2.59" length fits tight board spacing
- New condition guarantees full tip life from first use
Specifications
| Type | Soldering Tips |
|---|
Questions about this item
How often will the 1 mm conical tips need replacing on the ZD-931 station?
Tip life depends on solder type, temperature and flux; keep spares on hand as the 1 mm conical shape wears faster than chisel tips under daily use.
What limits continuous soldering with these tips on the ZD-931?
The narrow 1 mm point transfers less heat than broader tips, so heavy joints or ground planes will slow you down before the station reaches its own limits.
Do the ZD-931 tips run hotter or draw more power during long sessions?
Tip geometry does not change the station’s power draw; the iron maintains its set temperature regardless of tip shape during extended operation.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
