Ecco
Ecco ED3755AR Directional Lamp Amber/Red 12-24V 10.8W IP67
Flashing amber and red LED warning lamp rated SAE J595 Class 1 with IP67 sealing for 12-24V DC vehicles
- ColorAmber/Red
- SAE J595 Class 1 rating meets strict warning-light standards
- Amber/Red LED output gives high-visibility directional alerts
- IP67 sealing protects against dust and water ingress
- 12-24 V DC operation suits a wide range of vehicles
- 8 W draw keeps electrical load low
RV Perimeter Warning Lamp
The Ecco ED3755AR is a rectangular directional lamp designed for recreational vehicles and universal fleet applications. It uses LED technology to produce an amber and red flashing pattern that meets SAE J595 Class 1 requirements for high-visibility warning signals.
Permanent Mount with Blunt Cut Wires
Installation is permanent and the lamp connects via blunt cut wires directly into a 12-24V DC electrical system. The IP67 rating seals the housing against dust and water ingress, freeing the installer from additional weatherproofing steps around the 1-3/8 inch high by 5/8 inch deep profile.
Twelve LED Heads at 10.8 Watts
Twelve LED heads deliver the flashing output while drawing only 10.8 W across the operating voltage range. The SAE Class 1 rating confirms the intensity needed for perimeter warning duty, while the low power draw leaves ample headroom on typical RV lighting circuits.
Highlights
- SAE J595 Class 1 rating meets strict warning-light standards
- Amber/Red LED output gives high-visibility directional alerts
- IP67 sealing protects against dust and water ingress
- 12-24 V DC operation suits a wide range of vehicles
- 8 W draw keeps electrical load low
Specifications
| Brand | ECCO |
|---|---|
| Color | Amber/Red |
Questions about this item
How many LED heads are active in the Ecco ED3755AR when it runs continuously?
The lamp uses 12 LED heads in a rectangular array to produce its flashing amber/red pattern.
What is the power draw of the ED3755AR during all-day operation on a 12-24 V DC system?
It draws 10.8 W across the full 12-24 V DC range, keeping heat and current low for extended duty cycles.
Which wiring method must the installer provide to connect the blunt-cut leads on this lamp?
The fixture terminates in blunt-cut wires, so the installer must supply crimp connectors, solder joints or a terminal block to complete the circuit.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Taylor Made 12" x 18" Jolly Roger Novelty Flag 1818 marine electronic
- Accessories



