Eazypower Corp
Eazypower Corp 30045 Brad Point Drill Bit
High-speed steel brad point drill bit with a 3/8 in shank for accurate wood drilling
- Brad point tip reduces wandering for accurate hole starts
- High-speed steel construction resists wear during repetitive drilling
- 1-inch diameter bores large holes in a single pass
- 3/8-inch shank fits standard drill chucks without adapters
- Bright uncoated finish allows easy visual inspection of cutting edges
Eazypower 30045 Brad Point Bit
The Eazypower 30045 is a high-speed steel brad point drill bit designed for woodworking tasks that require clean, accurate holes. Its sharp centre point prevents the bit from wandering when starting a cut, making it suitable for cabinetry, furniture making and general joinery work where precision matters.
Replaces worn or smaller brad bits
This one-inch bit upgrades from smaller diameters when a project calls for larger dowel holes, hinge mortises or through-holes in thick stock. The five-inch maximum drilling depth handles deep bores in a single pass, so the step up is worthwhile whenever the job exceeds the reach or width of the bits currently in your set.
Fits 3/8-inch chucks, installs in seconds
The straight 3/8-inch shank locks into any standard drill chuck without adapters or special tooling. Because the bit is uncoated bright-finish HSS, it can overheat if run at high speed without clearing chips, so withdraw frequently and use a moderate feed rate to avoid burning the cutting edges.
Highlights
- Brad point tip reduces wandering for accurate hole starts
- High-speed steel construction resists wear during repetitive drilling
- 1-inch diameter bores large holes in a single pass
- 3/8-inch shank fits standard drill chucks without adapters
- Bright uncoated finish allows easy visual inspection of cutting edges
Specifications
| Brand | EAZYPOWER |
|---|
Questions about this item
Will the 3/8 in shank fit my drill chuck?
The bit has a straight 3/8 in shank diameter, so it fits any chuck that accepts 3/8 in or larger round shanks.
How do I keep the bit from wandering when I start the hole?
The brad-point tip centres itself on the workpiece; apply light pressure and let the point engage before increasing speed.
When will this bit need replacing?
High-speed steel dulls with use; resharpen the spurs and cutting lips when holes become rough or feed pressure rises.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
