Eaton
Eaton Aeroquip 2062-20-20S 90° Elbow Hydraulic Adapter
A 90-degree elbow hydraulic adapter with male JIC and male ORB connections rated for 2,000 psi
- 90-degree elbow routes hydraulic lines in tight spaces
- 2,000 psi rating handles high-pressure system demands
- Male JIC to male ORB connects two 1 1/4 in ports
- Carbon steel 12L14/12L15 construction resists wear and corrosion
- Includes O-ring for reliable seal without extra parts
Hydraulic Adapter Purpose
The Eaton Aeroquip 2062-20-20S is a 90 degree elbow adapter built for hydraulic hose systems. It connects a male ORB port to a male JIC port, each sized at 1 1/4 inch. The carbon steel construction suits industrial machinery and mobile equipment requiring a rigid, crimp-free joint.
Sustained Pressure Behaviour
Rated for 2,000 psi, the fitting maintains its seal under continuous operating pressure without the deformation seen in short burst tests. The included O-ring provides a reliable barrier against fluid loss during prolonged cycles. Carbon steel material resists fatigue in high vibration environments typical of heavy duty applications.
Installation Practicalities
The rigid 2.5 inch overall length demands precise port alignment before tightening, as the elbow cannot be rotated after assembly. Technicians must verify thread engagement on both the ORB and JIC ends to avoid cross threading the 12L14 or 12L15 steel. No crimping tools are required, but a proper wrench fit on the hex flats is essential for leak free installation.
Highlights
- 90-degree elbow routes hydraulic lines in tight spaces
- 2,000 psi rating handles high-pressure system demands
- Male JIC to male ORB connects two 1 1/4 in ports
- Carbon steel 12L14/12L15 construction resists wear and corrosion
- Includes O-ring for reliable seal without extra parts
Specifications
| Brand | EATON AEROQUIP |
|---|
Questions about this item
How much heat does the carbon-steel 90° elbow generate during continuous hydraulic operation?
The fitting is a passive carbon-steel component with no moving parts or electrical load, so it does not produce measurable heat under normal 2 000 psi service.
What thread standards must my existing hoses match for the male ORB and male JIC ends?
The adapter uses SAE J514 dimensions; one end is a male ORB port and the other a male JIC 1-5/8-12 thread, so hoses need corresponding female ORB and female JIC connections.
Will the 2.5 in overall length and 90° bend clear the fittings on my older SAE J514 hose assemblies?
The elbow follows SAE J514 geometry, so it aligns with legacy JIC and ORB ports of the same size; verify your existing hose-end clearance against the 2.5 in centre-to-end dimension.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
