Eagle Tool Us
Eagle Tool Us EM50054 Cable Installer Bit 1/2in 54in
Drills 52 in deep with a 1/2 in carbide tip on a 54 in powder-coated shaft
- 1/2 in drill bit bores large cable pathways
- 54 in overall length reaches deep cavities
- 52 in maximum drilling depth clears thick framing
- Carbide tip cuts cleanly through tough materials
- Powder-coated finish resists corrosion on job sites
Eagle Tool US EM50054 Cable Installer Bit
This 54-inch cable installer bit is designed for electricians and technicians who need to pull wire through long cavities in wood framing. The 1/2-inch cutting diameter creates a clean hole for standard cable bundles, while the 1/4-inch shank with three flats locks securely into a drill chuck. It is built for professional trade use in new construction and remodel projects where reach is critical.
Carbide Tip and Powder Coated Finish
The carbide tip resists wear when drilling through nail-embedded studs and abrasive sheathing, extending the usable life of the bit on tough job sites. A powder-coated flute surface reduces friction and helps clear chips during deep bore runs, keeping the bit cooler during continuous operation. These features combine to maintain cutting speed through the full 52-inch maximum drilling depth.
52-Inch Drilling Depth and 16-Inch Shank Clearance
The 54-inch overall length provides a 52-inch drilling depth, allowing a single pass through multiple wall plates and floor joists without repositioning. The 1/4-inch shank diameter and 3/16-inch hex flats limit compatibility to chucks that accept that size, so it will not fit larger 1/2-inch chuck-only drills. Users needing a smaller hole diameter or a shorter bit for tight crawl spaces will need a different tool.
Highlights
- 1/2 in drill bit bores large cable pathways
- 54 in overall length reaches deep cavities
- 52 in maximum drilling depth clears thick framing
- Carbide tip cuts cleanly through tough materials
- Powder-coated finish resists corrosion on job sites
Specifications
| Brand | EAGLE TOOL US |
|---|
Questions about this item
When will the carbide tip on this 1/2 in bit need replacement?
The carbide tip is built for long life in wood and masonry; replace it once the cutting edges no longer pull the bit cleanly through the hole.
What stops the bit from drilling deeper than 52 in?
The fluted section ends at 52 in, so chips can no longer clear and the bit binds if you push further.
How much heat builds up in the 54 in shaft during continuous drilling?
The powder-coated steel shaft dissipates heat quickly; in normal use the bit stays warm but not hot enough to discolor the coating.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
