Eagle Tool Us
Eagle Tool Us EHS37536 Flexible Drill Bit 3/8 in x 36 in
A flexible 36 in drill bit with a 3/8 in split-point tip for cable installation up to 32 in deep
- 3/8 in split point starts holes cleanly without wandering
- 36 in flexible shaft reaches through walls and ceilings
- 1/4 in hex shank locks securely in drill chucks
- Powder coated finish resists corrosion during extended use
- 32 in maximum drilling depth handles long cable runs
Flexible Drill Bit for Cable Installation
The Eagle Tool US EHS37536 is a split-point bit designed for pulling wire through framing cavities. Its 36-inch overall length reaches between studs and joists where standard bits cannot. The powder-coated finish resists corrosion during extended use.
Suited for Electricians and Low-Voltage Installers
The 3/8-inch diameter and 32-inch maximum drilling depth handle typical residential cable runs through wood. Builders needing larger holes for conduit or runs exceeding the 32-inch depth should select a different bit.
3/8-Inch Diameter with 1/4-Inch Hex Shank
The straight shank with three flats locks securely in a 1/4-inch hex chuck for positive drive. Comfortable headroom exists for standard NM and data cables; the bit runs out when hole diameter or drilling depth requirements exceed the stated specifications.
Highlights
- 3/8 in split point starts holes cleanly without wandering
- 36 in flexible shaft reaches through walls and ceilings
- 1/4 in hex shank locks securely in drill chucks
- Powder coated finish resists corrosion during extended use
- 32 in maximum drilling depth handles long cable runs
Specifications
| Brand | EAGLE TOOL US |
|---|
Questions about this item
What drill chuck size do I need for the 1/4 in hex shank?
The shank is a 1/4 in hex that fits any standard 3/8 in or 1/2 in keyed or keyless chuck.
Can the 36 in overall length reach through a 2x4 stud wall without removing drywall?
Yes, the 36 in bit provides a 32 in maximum drilling depth, long enough for typical stud cavities.
How do I confirm the split point is centred before drilling?
The split point self-centres on contact; start at low speed and watch the tip stay on the mark without wandering.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
