Eagle Tool Us
Eagle Tool Us EHS37524 Flexible Drill Bit 3/8 in x 24 in
A flexible drill bit with a 24 in overall length and a 22 in maximum drilling depth for cable installation
- Reaches tight spaces with 24 in overall length
- Drills up to 22 in deep for cable runs
- 3/8 in screw point starts holes cleanly
- 3/16 in hex shank fits standard chucks
- Powder-coated finish resists corrosion during use
Flexible Drill Bit for Cable Installation
The Eagle Tool US EHS37524 is a 3/8 in diameter flexible drill bit designed for cable installer work. Its 24 in overall length and 22 in maximum drilling depth suit electricians and low-voltage technicians pulling wire through studs, joists or insulated cavities. The screw point starts holes cleanly in wood without a pilot drill.
Shank Geometry Limits Chuck Compatibility
The 3/16 in hex shank with three flats fits only 1/4 in or larger three-jaw chucks and quick-change hex adapters. Smaller cordless screwdrivers with 1/4 in hex collets cannot grip the shank securely, so the bit is restricted to standard drill/drivers and right-angle drills that accept a 3/16 in hex shank.
Powder Coating and Reach Define Daily Use
A powder-coated finish resists corrosion when the bit contacts damp framing or insulation. The 24 in shaft reaches through double top plates and deep headers without extensions, while the flexible shaft follows curved paths inside finished walls. The fixed 3/16 in shank diameter prevents use with 1/2 in chuck-only drills.
Highlights
- Reaches tight spaces with 24 in overall length
- Drills up to 22 in deep for cable runs
- 3/8 in screw point starts holes cleanly
- 3/16 in hex shank fits standard chucks
- Powder-coated finish resists corrosion during use
Specifications
| Brand | EAGLE TOOL US |
|---|
Questions about this item
Should I choose the 24 in length or a shorter bit for tighter spaces?
The 24 in overall length with 22 in maximum drilling depth reaches through studs and joists; pick a shorter bit only if your cavity depth is less.
What does the 3/8 in diameter mean when I am drilling through framing?
It bores a 3/8 in hole suited for pulling NM cable or conduit through standard lumber without binding.
Will the 3/16 in hex shank fit my 1/2 in drill chuck?
Yes, the 3/16 in hex shank with three flats seats securely in any 3/8 in or 1/2 in keyed or keyless chuck.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
