Eagle Tool Us
Eagle Tool Us EC37536 Cable Installer Bit 3/8 in 36 in pneumatic accessory
A 36-inch cable installer drill bit with a 3/8-inch split-point tip and 3/16-inch hex shank for deep drilling
- Split-point tip starts holes cleanly without wandering
- 36 in overall length reaches through studs and joists
- 3/8 in drill size suits common cable diameters
- 3/16 in hex shank locks securely in drill chucks
- Powder-coated carbon steel resists corrosion during use
Eagle Tool US EC37536 Cable Installer Bit
This 36-inch cable installer bit is designed for routing wires through framed walls and ceilings. The split-point tip starts cleanly in wood without wandering. A 3/16-inch hex shank with three flats locks securely in drill chucks.
Electricians and low-voltage installers pulling
The 36-inch overall length suits standard wall cavities but will not reach through double-stud assemblies or deep floor trusses. Users needing shorter bits for tight boxes or longer bits for commercial chases should look elsewhere.
36-inch overall length
The bit drills to its full 36-inch length in a single pass, so the cavity depth must match. The 3/16-inch shank diameter limits torque transmission compared with larger-shank auger bits.
Highlights
- Split-point tip starts holes cleanly without wandering
- 36 in overall length reaches through studs and joists
- 3/8 in drill size suits common cable diameters
- 3/16 in hex shank locks securely in drill chucks
- Powder-coated carbon steel resists corrosion during use
Specifications
| Brand | EAGLE TOOL US |
|---|
Questions about this item
How do I install the 3/8 in cable installer bit into my drill chuck?
Insert the 3/16 in hex shank fully into the chuck and tighten securely on the three flats; the split-point tip self-centres so you do not need a pilot hole.
What maintenance or replacement will this bit need over time?
The carbon-steel cutting edges will dull after repeated use in wood or plaster; resharpen or replace the bit when the split point no longer starts cleanly.
What limit appears first during a long cable run with the 36 in bit?
The maximum drilling depth is 36 in, so a single pass cannot exceed the overall length of the bit itself.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
