We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Carbon steel ball valve with straight body and lever handle

Dynaquip Controls

Dynaquip Controls VAE2.A0 1 1/4 in FNPT Carbon Steel Ball Valve Trap

SKU CH-02Z5-5DJ12 MPN VAE2.A0

Carbon steel ball valve handles water at up to 600 psi with a 29 in Hg vacuum rating

  • TypeDrain Components
  • MaterialHAWA
  • Carbon steel body resists corrosion in water systems
  • Full-port ball design maintains unrestricted flow through the valve
  • 600 psi pressure rating handles demanding service conditions
  • Vacuum rated to 29 in Hg for negative-pressure applications
  • Non-locking handle allows quick manual operation

Purpose & Fit

The Dynaquip Controls VAE2.A0 is a two-way ball valve built from carbon steel for water lines. Its 1 1/4 inch FNPT connections suit industrial and commercial piping systems that require straight-through flow control. The full-port design matches the nominal bore so restriction stays minimal across the valve body. This valve is not intended for steam service, combustible gas lines or applications needing 3-A sanitary certification.

Thermals Noise & Power

The valve operates without external power so it generates no noise or heat of its own. Carbon steel construction handles the stated 600 psi maximum operating pressure and holds vacuum to 29 in Hg without leakage. Chrome-plated carbon steel ball and two-piece body maintain seal integrity through normal pressure and temperature cycles in water service.

Accessories & Software

No actuators, limit switches or locking handles are supplied with the valve. The non-locking lever allows manual operation only, so automated control requires separate hardware. No software or digital configuration is involved; installation is limited to threading the FNPT ends into the pipeline and verifying alignment.

Highlights

  • Carbon steel body resists corrosion in water systems
  • Full-port ball design maintains unrestricted flow through the valve
  • 600 psi pressure rating handles demanding service conditions
  • Vacuum rated to 29 in Hg for negative-pressure applications
  • Non-locking handle allows quick manual operation

Specifications

TypeDrain Components
MaterialHAWA
BrandDynaquip Controls
ModelVAE2.A0 1 1/4

Questions about this item

How do I install the VAE2.A0 valve on a 1 1/4 in FNPT pipe without damaging the carbon steel body?

Use a pipe wrench on the valve end flats only, tighten to the thread engagement depth, and avoid clamping the body or handle.

What maintenance will the chrome-plated carbon steel ball and non-locking handle need over time?

Cycle the valve quarterly to prevent seizing, inspect the seat for wear, and replace the handle if the lever cracks.

At what pressure limit should I stop increasing flow on the 4,600 psi rated valve during sustained operation?

Do not exceed 4,600 psi operating pressure; sustained use near this limit can accelerate seat deformation.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.